RFID eliminates overhead wiring for trams

A new RFID system developed by UK company Harting allows electric trams or buses to operate without overhead electric wiring in areas where it would be unacceptably obtrusive, such as historic town centres, or where it might cause interference to sensitive equipment.
May 11, 2015 Read time: 1 min

A new RFID system developed by UK company 8098 Harting allows electric trams or buses to operate without overhead electric wiring in areas where it would be unacceptably obtrusive, such as historic town centres, or where it might cause interference to sensitive equipment.

The use of RFID enables a vehicle to detect the location of a charging station in advance or to determine which operating mode it is permitted to drive in. Harting Ha-VIS RFID systems permit approach detection to a charging station with positioning accuracy of better than 50cm. In addition, the RFID transponder contains information on the authorised operating mode. The RFID transponder may be mounted on a platform, on the track or at a stop, even within concrete to protect from vandalism.

Related Content

  • July 30, 2013
    Tollers make way as NextNav muscles into 902-928MHz spectrum
    Toll operators and Progeny trade claim and counter claim about the potential ramifications of operating in the 902-928MHz spectrum, as Jon Masters finds out. Two months after the Federal Communications Commission (FCC) determined that Progeny can start commercial operation of its NextNav location finding service, the dust has begun to settle. The tolling industry has had a chance to reflect on how this may impact its operations, in the knowledge that NextNav will share the 902-928MHz frequency band with RFI
    Read More
  • February 8, 2016
    Accurate vehicle detection with Radix wired sensors
    Radix Traffic will be featuring at Intertraffic Amsterdam its wired magnetometer sensors, over 500 of which have been installed in the UK to provide accurate vehicle detection. Unlike conventional inductive loops, the sensors can be installed around 50cm below the road surface where they are protected from damage caused by bad weather and heavy traffic. Radix claims that once a sensor is installed it will continue to detect during its 15-year design life with no maintenance required. Radix says installat
    Read More
  • April 5, 2016
    Radix Traffic features wired magnetometer sensors
    Radix Traffic will be featuring at Intertraffic its wired magnetometer sensors, over 500 of which have been installed in the UK to provide accurate vehicle detection. Unlike conventional inductive loops, the sensors can be installed around 50cm below the road surface where they are protected from damage caused by bad weather and heavy traffic. Radix claims that once a sensor is installed it will continue to detect during its 15-year design life with no maintenance required.
    Read More
  • April 24, 2013
    Vehicle identification systems aid dynamic bus operations
    David Crawford looks at a global trend towards more efficiency in less space As buses gain increased profile in the public transport mix needed for modal shift, attention is turning towards improving terminal layouts for more efficient handling of services and passengers. Locations, too, tend to be in central areas of cities, where sites are restricted and land values high. Enter the dynamic bus station, which uses modern vehicle identification systems to optimise space use and streamline service operation
    Read More

Highlighted Content