J-J Hooks barrier system passes demanding crash tests

Easi-Set Worldwide has announced that its J-J Hooks barrier system has successfully passed both bolted-down and pinned-down MASH Test Level 3 crash tests (MASH - Manual for Assessing Safety Hardware), out-performing other comparable systems. The tests were performed by the Texas Transportation Institute.
June 19, 2012 Read time: 1 min
5948 Easi-Set Worldwide has announced that its J-J Hooks barrier system has successfully passed both bolted-down and pinned-down MASH Test Level 3 crash tests (MASH - Manual for Assessing Safety Hardware), out-performing other comparable systems. The tests were performed by the 232 Texas Transportation Institute.

Prior to these tests, over 41 states/provinces and eight countries have approved the free-standing J-J Hooks temporary barrier for use on their highways. This temporary barrier successfully passed NCHRP 350 TL3 tests in the 1990’s, qualifying it for approval as an alternate to existing state/provincial standard barrier designs. Easi-Set is identifying this barrier as J-J Hooks/NCHRP.

The anchored J-J Hooks design, dubbed J-J Hooks/MASH, incorporates an enlarged J-Hook, additional reinforcing to absorb the higher impact loads, and patented deflection limiting blocks.

Both designs connect seamlessly to each other and they can be placed in the same installation without the need for a transition section. This allows one installation to satisfy up to three different performance requirements. Both J-J Hooks designs are available in cross-sections commonly used on existing highways.

For more information on companies in this article

Related Content

  • British Columbia's highway corridors show it’s good to share
    June 6, 2025
    The Canadian province is advocating harmony along its major roads, setting aside major funding for projects to allow vehicles and other modes to operate safely side by side, reports David Arminas
    Read More
  • Dynamic Message Signs : Don’t replace, refurbish and upgrade
    August 12, 2015
    Refurbishing old dynamic message signs can save money and increase technical capabilities as David Crawford discovers. Evidence is growing on both sides of the Atlantic of the scope for retrofitting old or technically out-of-date dynamic message signs (DMS) with new electronic equipment, to save on the costs of installing full-scale replacements. In the last four months of 2014, a number of US states progressed programmes that achieved savings of more than US$1.75 million (€1.56million).
    Read More
  • Drive C2X ‘proves Europe is ready for cooperative systems roll-out’
    July 16, 2014
    The DRIVE C2X provides a comprehensive, Europe-wide assessment of cooperative systems through field operational tests, and is to present its results on 16 and 17 July in Berlin. The test results are the last step in the preparation for the roll-out of cooperative systems in Europe. During the three and a half years of the project, more than 750 drivers tested eight safety-related functions of cooperative functions all over Europe. The operational tests took place in seven test sites in Finland, France, G
    Read More
  • Measuring alertness to avert drowsy driver incidents
    December 21, 2015
    Falling asleep at the wheel is the primary cause in thousands of deaths on American and other roads, with truck drivers the most at-risk group. David Crawford investigates measures to counter drowsy driving.
    Read More

Highlighted Content