Eberle Design data aggregator provides real time performance measures and traffic data

Among a range of new products that Eberle Design Inc. (EDI) and Reno A&E will feature at ITS America 2016 San Jose will be the recently launched iCite Data Aggregator DA-300 that provides cost effective remote access to real-time performance measures and traffic data from any isolated or networked intersection or arterial roadway.
May 27, 2016 Read time: 2 mins

Among a range of new products that 41 Eberle Design Inc. (EDI) and 7435 Reno A&E will feature at ITS America 2016 San Jose will be the recently launched iCite Data Aggregator DA-300 that provides cost effective remote access to real-time performance measures and traffic data from any isolated or networked intersection or arterial roadway.

EDI says it easily interfaces with any make or model of traffic cabinet or controller, (NEMA, ATCC or Type 170/2070), to provide real-time traffic counts, and parsed data which can be used to derive a variety of data analytics which may include Levels of Service, Vehicle Occupancy, Arrivals on Red and High Density Detector Data.

The iCite Data Aggregator DA-300 provides Wi-Fi-based roadway network travel time and much more. It monitors and reports on mission critical traffic cabinet or intersection faults via SMS or email. It’s also designed to endure temperature extremes and well suited for solar powered applications.

Also on the booth will be the new Reno A&E intersection Malfunction Management Unit which is setting new standards in reliability and functionality. The MMU2-1600GE and MMU2-1600G monitors are fully compliant with the recently updated NEMA TS2:2003 (R2008) Standard for Traffic Controller Assemblies, (Amendment #4-2012).

According to the company, these units can be programmed for eight-phase, dual-ring operations by answering a series of questions presented on the monitor. The Wizard can setup the eight Flashing Yellow Arrow (FYA) Types (A-H) defined by the NEMA Amendment 4-2012. The Wizard can set up eight additional Flashing Yellow Arrow Types (I-P). The Wizard will set the proper configurations and check the program card jumpers for any configuration issues. Selecting "Easy FYA Programming" allows standard program card programming for FYAs.

For more information on companies in this article

Related Content

  • StreetLight Data provides free VMT metrics
    April 17, 2020
    StreetLight Data is offering vehicle miles travelled (VMT) data for US transit agencies to monitor transport networks and understand travel patterns during the Covid-19 pandemic.
    Read More
  • Bluetrace boosts detection rates without privacy concerns
    June 15, 2015
    Vehicle counting and travel time determination is said to be easier and more accurate using Bluetrace which detects both Bluetooth and Wi-Fi signals from motorists smart phones. According to the Netherlands-based company's UK importer Rennicks, only 10% of mobile phone owners have Bluetooth activated whereas most have the Wi-Fi switched on leading to a hit rate of 98% which increase accuracy and granularity while maintaining the anonymity of a non-ANPR system.
    Read More
  • Challenges and benefits of adaptive signal control
    April 23, 2013
    Delcan’s Joe Lam, who managed the first computerised signal system in the world, provides an expert insight into adaptive signal control. There are no gadgets in the world that regulate our daily behaviour as much as traffic signals, except perhaps our mobile phones. It has been estimated that the daily commuter goes through at least 10 signals on his journey to work. However, unlike mobile phones, traffic signals cannot be ignored or switched off by their daily users, at least not without legal consequence
    Read More
  • Siemens’ Plus+ simplifies signalised intersection wiring
    June 2, 2017
    The latest innovation from Siemens comes under the Plus+ banner and encompasses its third generation digitised traffic control system which features distributed intelligence and simplifies cabling. In place of up to 300 wire cores on a single signalised intersection, the Plus+ system uses just four cables arranged in a system of rings, arms and spurs. The four wires, two power (48V) and two data, are used to connect ‘intelligent nodes’ in each traffic light head to be connected to the central controller, re
    Read More

Highlighted Content