Actibump installed at Curtain University to tackle speeding

Curtin University Campus in Perth, Australia, has activated two of Edeva’s ActiBump systems along a road traversing around its campus to combat an estimated 70% of vehicles driving over the speed limit. Both platforms have been installed during the Summer break. ActiBump is said to allow users to set the speed limit and other variables via software, which is also programmable for other applications. David Eskilsson, general manager at Edeva, the inventor of the Actibump, said: “The system collects speed
March 23, 2018 Read time: 1 min
Curtin University Campus in Perth, Australia, has activated two of Edeva’s ActiBump systems along a road traversing around its campus to combat an estimated 70% of vehicles driving over the speed limit. Both platforms have been installed during the Summer break.

ActiBump is said to allow users to set the speed limit and other variables via software, which is also programmable for other applications.

David Eskilsson, general manager at Edeva, the inventor of the Actibump, said: “The system collects speed data for every passing vehicle. We are looking at the results and are already seeing a decrease of the number of speeding vehicles. We recognise this trend from our Swedish installations.”
Urban Traffic Control

Related Content

  • July 31, 2014
    Upsala installs Actibump traffic calming
    The Swedish city of Uppsala has become the third city in the country to install Edeva’s Actibump in a bid to improve traffic congestion on a busy four-lane road. According to Edeva, its Actibump traffic calming solution creates road safety through greater compliance with speed limits. Actibump is a metal trough six centimetres deep in the road surface, which the developers say is deep enough for drivers to notice, but not so deep as to cause damage to the vehicle. The system utilises a roadside rad
    Read More
  • September 24, 2014
    Actibump installation shows results
    Trials in the city Linköping have shown the effectiveness of Edeva’s Actibump speeding deterrent. The average speed on the road, which is used by 5,000 vehicles per day, decreased from 36 to 32km/h following the installation of the device. Actibump comprises of a 6cm deep metal trough set in the road surface and utilises a roadside radar unit to monitor vehicle speed. If a speeding vehicle is detected the flat metal plate which normally covers the trough is activated and pivots downwards, exposing an edge
    Read More
  • May 18, 2018
    On-road and in-vehicle are not in competition
    The integrity and accuracy of data that can be verified by weigh-in-motion technology has been improving for decades – and the range of WIM applications is increasing at a tremendous pace. Chris Koniditsiotis, president of the International Society for Weigh-in-Motion (ISWIM) and CEO of Transport Certification Australia (TCA), began his career in 1985 as a pavements engineer. “When I joined this portfolio, the integrity, accuracy, and sampling frequency of mass information delivered at best an estimate, us
    Read More
  • September 6, 2018
    Sweden installs Actibump systems in the city of Ystad
    The Swedish Transport Administration (Trafikverket) has installed Edeva’s traffic system speed bumps on the E65 road in the city of Ystad. Called Actibump, the solution is intended to improve safety and accessibility for pedestrians and cyclists crossing the street from Ystad harbour. Actibump detects if the speed of an oncoming vehicle is above the limit and lowers a hatch a few centimetres into the road surface to remind the driver of the speed limit.
    Read More

Highlighted Content