Weigh in motion with high speed strip scales

Intercomp’s latest high-speed strip scales provide in-ground weigh-in-motion capabilities and are said to feature industry-leading strain gauge load cell technology for increased accuracy, repeatability and fast response times. The scales exceed ASTM E1318-09 Type I, Type II, Type III, and COST 323 B+(7) or B(10) requirements for high volume data collection and screening for direct enforcement.
December 18, 2014 Read time: 1 min
Intercomp strip scale

1982 Intercomp’s latest high-speed strip scales provide in-ground weigh-in-motion capabilities and are said to feature industry-leading strain gauge load cell technology for increased accuracy, repeatability and fast response times. The scales exceed ASTM E1318-09 Type I, Type II, Type III, and COST 323 B+(7) or B(10) requirements for high volume data collection and screening for direct enforcement.

They can be installed in one day in grooves less than 75mm (3inch) wide; minimising lane closures. The system weighs vehicles dynamically in the mainline axle-by-axle as they pass over the scales at speeds up to 129km/h (80mph).

The system includes two strip scales units, but can be configured with four or six strips per lane for higher sampling rates. They can be integrated into a user’s existing system with analog output, or coupled with Intercomp’s WIMLOGIX module which provides signal conditioning, data acquisition and basic processing.

Classification & Data Collection

For more information on companies in this article

Related Content

  • Transition to all electronic tolling leads to cost savings
    February 2, 2012
    How a temporary congestion-relief solution resulted in the North Texas Tollway Authority's transition to all-electronic toll collection and potential savings of up to $472 million by 2045. By Carla Kienast, ETC Corporation
    Read More
  • Remote remedies help US authorities identify bridge deficiencies
    September 6, 2017
    Every day 185 million vehicles – cars, trucks, school buses, emergency response units - cross one or more of America’s 55,710 'structurally compromised' steel and concrete road bridges, the highest concentration of which are in Iowa (nearly 5,000), Pennsylvania and Oklahoma. Nearly 2,000 of these crossings are located on interstate highways, according to the American Road and Transportation Builders Association's recent analysis of the US Department of Transportation's 2016 National Bridge Inventory.
    Read More
  • VanJee will focus on its Lidar systems
    March 20, 2024
    Beijing-headquartered VanJee, a global ITS and lidar company, will be showcasing its innovative WLR-733 real time scanning radar.
    Read More
  • European tunnel safety steps up a gear
    September 19, 2017
    David Crawford reviews the latest safety systems installed in European tunnels. Blueprints for the safer road tunnels of the future are emerging fast as European operators invest in technologies to enhance travellers’ prospects of surviving an accident. Central to modern emergency planning is the principle that, following an incident, drivers should be enabled to rescue themselves and their passengers with the aid of prompt and correct identification and communication of the hazard. Roles for cooperativ
    Read More

Highlighted Content