Skip to main content

Hella showcases solutions to advance autonomous driving

To enable higher levels of autonomous driving and allow OEMs and drivers the freedom to create more customized vehicles, Hella is showcasing its multifunctional sensor at the North American International Auto show 2018, in Detroit. The solution comes with three detection functions based on its environmental awareness capabilities. Called Structural Health and Knock Emission (Shake) sensor, it has been upgraded to recognise structure-borne sound waves generated by contact or knocks on its body through
January 16, 2018 Read time: 2 mins

To enable higher levels of autonomous driving and allow OEMs and drivers the freedom to create more customized vehicles, 226 Hella is showcasing its multifunctional sensor at the North American International Auto show 2018, in Detroit. The solution comes with three detection functions based on its environmental awareness capabilities.

Called Structural Health and Knock Emission (Shake) sensor, it has been upgraded to recognise structure-borne sound waves generated by contact or knocks on its body through piezoelectric foil.

Shake’s adaptive impact detection uses two sensors on the front and rear of the vehicle to detect slight touches of other cars or pedestrians to its bumper at speeds up to approximately 12mph. It can also trigger a signal to stop vehicles to prevent further damage as well as detect contact and perform an emergency stop if any collision with obstructions occurs during parking.

The intelligent damage detection identifies the severity as well as the time and place of vehicle damage, including scratches, dents and paint damage. It also creates damage reports for owners and mobility companies, who may use autonomous vehicles in car-sharing applications.

In addition, smart touch detection offers drivers convenience and safety features by enabling them to control the vehicle with the touch of their hand.

Hella’s demo will also present an opportunity for attendees to witness its welcome lighting technologies as well as how lights can project graphics onto the ground, among other functions.

Related Content

  • April 9, 2014
    ITS homes in on cycling safety
    A new generation of ITS equipment is helping road authorities get to grips with cycle safety – and not a moment too soon as Colin Sowman discovers. Cyclists - remember them? Apparently not. At least not according to the OECD 2013 report Cycling, Health and Safety which contains the statement: ‘Cyclists are often forgotten in the design of the road traffic system’. Looking through the statistics that exist (each country appears to compile them differently) it is not difficult to see how such a conclusion cou
  • June 9, 2015
    Looking both ways for speeding vehicles
    Single-camera bi-directional speed enforcement can reduce the cost of enforcing speeding on two-way roads without repositioning the camera. Truvelo has received UK type-approval for a simultaneous bi-directional (SBD) enforcement camera, the D-Cam P digital, which can capture speeding motorist both those travelling towards and away from the camera. It is also in the process of carrying out the first installations of the D-Cam P in the UK.
  • October 28, 2014
    Machine vision offers new solutions to old problems
    The transportation sector is set to benefit from a far wider range of machine vision technology. While machine vision techniques have been applied to traffic management applications for some years, in some areas there can still be a shortage of knowledge about what the technology can offer transportation professionals. The image processing and interpretation functions of machine vision enables control room staff to be immediately alerted to occurrences requiring attention which, in turn, enables each person
  • June 2, 2014
    Machine vision makes progress in traffic applications
    Machine Vision technology is easing the burden on hard-pressed control room staff and overloaded communications networks.