Skip to main content

NCDOT to install advance traffic warning system on I-277

The North Carolina Department of Transportation (NCDOT) is to install an advance warning system on the Interstate 277 (I-277) outer loop between Tryon Street and Interstate 77 in Charlotte, North Carolina. This system will detect traffic data such as volume and speed, alerting motorists to backups that frequently occur on the ramp from I-277 outer to I-77 north. The $188,000 project was awarded to Consolidated Power of Mooresville, who will install the detection warning system, consisting of two microwave
October 16, 2012 Read time: 2 mins
The 4775 North Carolina Department of Transportation (NCDOT) is to install an advance warning system on the Interstate 277 (I-277) outer loop between Tryon Street and Interstate 77 in Charlotte, North Carolina.

This system will detect traffic data such as volume and speed, alerting motorists to backups that frequently occur on the ramp from I-277 outer to I-77 north.

The $188,000 project was awarded to Consolidated Power of Mooresville, who will install the detection warning system, consisting of two microwave vehicle detection (MVD) units and two flashing LED beacons.  The MVD units will collect traffic data and send it to a processor on site for analysis; the system will then send a message to activate one or both of the flashing beacons.

Once traffic reaches speeds below 20 mph, the first beacon near the I-77 North exit ramp will activate. If traffic continues to back up toward Tryon Street, the second beacon will be activated. The contract also requires additional signage warning motorists of slow or stopped traffic.

NCDOT operates other similar detection systems on NC 58 in Carteret County, on I-26 in Polk and Henderson Counties, and on I-40 in Iredell County.

For more information on companies in this article

Related Content

  • Austria’s answer to temporary traffic problems
    December 22, 2015
    ASFINAG has developed a mobile traffic monitoring and guidance system through a pre-commercial procurement project. Drivers have become accustomed to roadside and gantry-mounted traffic guidance and control systems along the major roads and main motorway sections. But there are occasions when intense monitoring is required on a temporary basis along motorway sections without traffic guidance and control systems and on federal and national roads too. Examples include the monitoring of the traffic flow during
  • Traffic roundabouts, a steep learning curve
    October 1, 2014
    Drivers in the UK are very familiar with the concept of traffic roundabouts at intersections, which are designed to keep traffic moving more efficiently than a traditional signal-controlled intersection. However, according to a report on the US Government Executive website, drivers in some parts of the US don’t understand them. In Oakland County, just outside Detroit, some roundabouts have seen big spikes in crashes and property damage since they were built, but the severity of those accidents has been
  • Here’s why WiM is value for money
    January 23, 2025
    Weigh in Motion systems are not new. What is new is their ability to collect more data and – importantly – more accurate data about axle loading and vehicle weight. Despite the obvious benefits, including safer highways and possibility of automated legal weight enforcement, obstacles remain for faster uptake. David Arminas reports on the manufacturers’ perspective…
  • Vehicle probe data aids emergency rescue vehicle routing
    June 20, 2012
    A new vehicle routeing initiative has arisen to help improve emergency response and relief following natural disasters in Japan. David Crawford reports Japan’s national ITS group ITS Japan and the country’s leading automotives have agreed on a new combined approach to the organisation of traffic management and emergency response in the wake of major natural disasters. A new, robust traffic information platform using probe data obtained from vehicles to support traffic flow will build on the shared experienc