Multi-sensor signal conditioner

A signal conditioner that provides clean sensor power supply and output amplification for precision dynamic measurement of pressure and vibration has been introduced by Measurement Specialties.
February 3, 2012 Read time: 1 min
A signal conditioner that provides clean sensor power supply and output amplification for precision dynamic measurement of pressure and vibration has been introduced by 2205 Measurement Specialties. The new Model 101 three-channel DC differential voltage amplifier features DC to 200kHz bandwidth for fast response. Its discrete channels provide clean sensor power supply (0-12Vdc) and output magnification (0-999 gain) for three sensors simultaneously.

According to Measurement Specialties, the amplifier is designed to work with any piezoresistive bridge-configuration transducer such as accelerometers, vibration and pressure sensors, force sensors and load cells. Applications include automotive crash testing, wind tunnel testing, structural testing for seismic resistance and weighing.

Input signals with magnitudes of ±10Vdc can be zeroed, and a unique DAC routine allows output zero to be trimmed to within ±1mVdc. The microprocessor controlled conditioner features 10Vdc peak linear output and 0.5 per cent FS output accuracy. It provides multi-sensor support, variable gain adjustment, shunt calibration capability and multiple excitation level settings. A wide selection of optional frequency roll-off filters is available.

For more information on companies in this article

Related Content

  • Moxa's ToughNet
    March 12, 2012
    Moxa has announced a new series of EN50155 Ethernet switches which satisfy the strictest railway industry standards. To deliver the tough performance required by complex railway and road communication systems, ToughNet series products have rounded M12 connectors to endure and withstand persistent and frequent vibration or shock. The company says the design concept emphasises the highest level of reliability and availability by offering strong EMI immunity, a -40 to +75°C operating temperature range, IP54/67
    Read More
  • Solar cell technology cameras
    February 2, 2012
    A new camera range from Stemmer Imaging uses a sensor, based on solar cell technology, to allow imaging from scenes which simultaneously contain both very light and very dark areas. The company says this makes them ideally suited to use in environments with a very high dynamic range, or where there are strong and unpredictable brightness fluctuations. The new FX4 HDR (High Dynamic Range) sensor produces a logarithmic signal output. This enables fine differences in brightness to be imaged even in very bright
    Read More
  • New Nortech IR200 provides intelligent vehicle loop detection
    October 11, 2016
    Today's traffic systems thrive on data, which is why Nortech Detection is debuting its IR200 intelligent vehicle loop detector at the ITS World Congress. Designed for motorway use, the IR200 collects, stores and reports multi-lane traffic data derived from 32 loops (or 16 lanes in speed measurement mode) at vehicle speeds to 200km/h. The IR200 incorporates incident detection capability implemented at the roadside. Using the TRRL HIOCC algorithm, the equipment monitors traffic occupancy per lane on a seco
    Read More
  • Advantech's ADAM-6100 Series
    January 30, 2012
    Advantech's ADAM-6100 series is a new line of industrial Ethernet remote Input/Output (I/O) modules, seven of which are designed with the Ethernet/IP protocol and seven based on Profinet. Four of the Ethernet/IP-based modules have just been released, the 6150EI, a 15-channel isolated digital I/O Ethernet/IP module, the 6151EI, a 16-channel isolated digital input Ethernet/IP module, the 6156EI, a 16-channel isolated digital output Ethernet/IP module, and the ADAM-6160EI, a six-channel relay output Ethernet/I
    Read More

Highlighted Content