Multi-sensor signal conditioner

A signal conditioner that provides clean sensor power supply and output amplification for precision dynamic measurement of pressure and vibration has been introduced by Measurement Specialties.
February 3, 2012 Read time: 1 min
A signal conditioner that provides clean sensor power supply and output amplification for precision dynamic measurement of pressure and vibration has been introduced by 2205 Measurement Specialties. The new Model 101 three-channel DC differential voltage amplifier features DC to 200kHz bandwidth for fast response. Its discrete channels provide clean sensor power supply (0-12Vdc) and output magnification (0-999 gain) for three sensors simultaneously.

According to Measurement Specialties, the amplifier is designed to work with any piezoresistive bridge-configuration transducer such as accelerometers, vibration and pressure sensors, force sensors and load cells. Applications include automotive crash testing, wind tunnel testing, structural testing for seismic resistance and weighing.

Input signals with magnitudes of ±10Vdc can be zeroed, and a unique DAC routine allows output zero to be trimmed to within ±1mVdc. The microprocessor controlled conditioner features 10Vdc peak linear output and 0.5 per cent FS output accuracy. It provides multi-sensor support, variable gain adjustment, shunt calibration capability and multiple excitation level settings. A wide selection of optional frequency roll-off filters is available.

For more information on companies in this article

Related Content

  • Is it time for a harmonised international standard for Weigh in Motion?
    May 15, 2024
    Weigh in Motion vendors are frustrated that OIML accreditation is not proving to be enough to satisfy tenders in some countries. In this article, the board of the International Society for Weigh in Motion suggests a possible way forward…
    Read More
  • Additional functionality gives loops a continued lease of life
    March 20, 2014
    Two decades after the death of the inductive loops was predicted, Matt Zinn, technical services manager at Eberle Design says the technology still offers advantages. More than 20 years ago the emergence of video detection systems led many to foretell the end of inductive loops. In the intervening years advocates of radar, infrared and wireless detection technologies have also claimed that loops were on their way out. But in fact, by all calculations, the use of loops has actually increased and although
    Read More
  • Bluetooth and Wi-Fi offer new options for travel time measurements
    November 20, 2013
    New trials show Bluetooth and Wi-Fi signals can be reliably used for measuring travel times and at a lower cost than an ANPR system, but which is the better proposition depends on many factors. Measuring travel times has traditionally relied automatic number plate (or licence plate) recognition (ANPR/ALPR) cameras capturing the progress of vehicles travelling along a pre-defined route. Such systems also have the benefit of being able to count passing traffic and have become a vital tool in dealing with c
    Read More
  • TunnelCam booststunnel safety
    March 13, 2018
    TKH Security Solutions’ TunnelCam Ultimo is designed for tunnel applications and is able to withstand corrosive exhaust gases and vibrations, as well as high-pressure water jets used during periodical tunnel cleaning. Compact and lightweight, the Ultimo can be installed by one person, offers cross-sensor intelligence possibilities and users can interchange optical and thermal views over a single IP address. Its ability to capture clear images and locate heat sources provides tunnel safety and fire
    Read More

Highlighted Content