Intercomp showcases In-ground WIM

Intercomp is showcasing its continued success with weigh-in-motion (WIM) strip sensors for weight based applications, the company’s sensors and systems have recently been installed in Europe, Asia, and both North and South America.
October 7, 2016 Read time: 1 min
Eric Peterson of Intercomp displays the WIM sensor
1982 Intercomp is showcasing its continued success with weigh-in-motion (WIM) strip sensors for weight based applications, the company’s sensors and systems have recently been installed in Europe, Asia, and both North and South America.

Grouted into three inch (75mm) channels cut into the pavement, the strain gaugebased strip sensors detect axle weights, vehicle weights and use axle spacing to determine vehicle classifications. Operating over a wide range of temperatures, configurations of these sensors are used in data collection, screening for enforcement, tolling (ETC), and industrial applications.

According to Intercomp, its strain gauge-based strip sensors enable accurate weighing technology, usually reserved for static scales, to be used at speeds up to 80mph (130km/h).

Site accuracies exceed COST A(5) and ASTM Type III requirements across a wide range of vehicle speeds. Installed in a vehicle lane within a single day with minimal civil works required, lane closures are kept to a minimum to incorporate and update WIM sites.

Supplied within a complete system or integrated with existing electronics and software platforms, users have the flexibility to incorporate the WIM sensors at standalone sites or within current infrastructure.

Related Content

  • July 3, 2015
    Weigh-in-motion scales aid container terminal efficiency
    Intercomp weigh-in-motion (WIM) scale systems have been installed for use in the lanes at the West Basin Container Terminal (WBCT) within the Port in Long Beach, California, to automate the weighing process and replacing the older static truck scales. Intercomp’s LS-WIM weigh-in-motion systems feature industry-leading strain gauge load cell technology, the same type used in static truck scales for increased accuracy, repeatability and fast response times. The small footprint of the scales compared to
    Read More
  • July 31, 2012
    Developing an integrated WIM/ANPR enforcement system
    The weigh in motion market remains especially buoyant and technological development continues to reflect this. Although there are major differences in operating philosophies, particularly between developed and developing countries, both the numbers of countries using Weigh In Motion (WIM) technology and the numbers of systems that they deploy are on the increase.
    Read More
  • May 8, 2015
    IRD complements WIM with tyre under-inflation detection
    To complement its existing WIM offering, IRD has introduced a system to detect under-inflated and flat tyres at highway speeds. Tyre inflation pressure has both safety and economic impacts for road users and none more so than with commercial vehicles. An underinflated tyre has decreased directional control, increased risk of catastrophic failure, and negatively impacts tyre life and fuel economy. In June 2014 the USDOT published Large Truck and Bus Crash Facts 2012 in which the Federal Motor Carrier Safety
    Read More
  • February 28, 2019
    Intercomp launches LS-WiM system for fleet operators
    Intercomp has launched a low-speed Weigh in Motion (LS-WiM) system which it says allows fleet managers to collect the weight of vehicles without hampering traffic flow. The system is suitable for high-volume entry and exit gates and, unlike full-length truck scales, does not require incoming and outgoing traffic to stop every time a vehicle needs to be weighed, the company adds. According to Intercomp, the system’s small footprint allows it to be installed at most facilities at approximately half the co
    Read More

Highlighted Content