Intercomp showcases In-ground WIM

Intercomp is showcasing its continued success with weigh-in-motion (WIM) strip sensors for weight based applications, the company’s sensors and systems have recently been installed in Europe, Asia, and both North and South America.
October 7, 2016 Read time: 1 min
Eric Peterson of Intercomp displays the WIM sensor
1982 Intercomp is showcasing its continued success with weigh-in-motion (WIM) strip sensors for weight based applications, the company’s sensors and systems have recently been installed in Europe, Asia, and both North and South America.

Grouted into three inch (75mm) channels cut into the pavement, the strain gaugebased strip sensors detect axle weights, vehicle weights and use axle spacing to determine vehicle classifications. Operating over a wide range of temperatures, configurations of these sensors are used in data collection, screening for enforcement, tolling (ETC), and industrial applications.

According to Intercomp, its strain gauge-based strip sensors enable accurate weighing technology, usually reserved for static scales, to be used at speeds up to 80mph (130km/h).

Site accuracies exceed COST A(5) and ASTM Type III requirements across a wide range of vehicle speeds. Installed in a vehicle lane within a single day with minimal civil works required, lane closures are kept to a minimum to incorporate and update WIM sites.

Supplied within a complete system or integrated with existing electronics and software platforms, users have the flexibility to incorporate the WIM sensors at standalone sites or within current infrastructure.

For more information on companies in this article

Related Content

  • SeeDOT spots trucking transgressors
    June 1, 2015
    SeeDOT, from vehicle recognition specialist HTS, uses multiple 2MP IP imaging units with customised visible, near and invisible synchronised illumination to automatically monitor commercial vehicles entering and exiting controlled areas such as Ports of Entry, border crossings and weigh-in-motion stations. The system is said to operate effectively at both moderate and high speeds in mainline, virtual and ramp applications to capture details including DOT, LPR, Overview, KYU and Jurisdiction. HTS says Se
    Read More
  • Wider uses for weigh in motion data
    March 18, 2014
    Colin Sowman talks to Terry Bergan of International Road Dynamics about the latest uses of weigh-in-motion systems. Raising allowable truck weight limits improve transport efficiency but leaves an ever-increasing number of bridges vulnerable to being overloaded and damaged by vehicles heavier, and in some cases far heavier, than they were designed to carry. The simplistic solution is to impose weight restrictions and erect appropriate signs - but this could have severe knock-on effect on trucking operations
    Read More
  • Weigh in Motion gets smarter
    January 4, 2023
    Weigh in Motion technology is at the forefront of protecting road surfaces and helping enforcement activity – but could it also play a key role in the development of Smart Cities?
    Read More
  • IRD demonstrates the power of VectorSense
    September 8, 2014
    For many attendees, this ITS World Congress will be their first exposure to IRD’s VectorSense sensor suite – a new technology recently introduced at the ITS Europe conference in Helsinki. An operating model was later demonstrated at the 2014 NatMec conference in Chicago.
    Read More

Highlighted Content