Hella showcases solutions to advance autonomous driving

Hella has launched a multifunctional sensor which aims to enable higher levels of autonomous driving and allow OEMs and drivers the freedom to create more customised vehicles. It comes with three detection functions based on its environmental awareness capabilities and has been exhibited at the North American International Auto show 2018, in Detroit. Called Structural Health and Knock Emission (Shake) sensor, it has been upgraded to recognise structure-borne sound waves generated by contact or knocks on it
June 26, 2018 Read time: 2 mins

226 Hella has launched a multifunctional sensor which aims to enable higher levels of autonomous driving and allow OEMs and drivers the freedom to create more customised vehicles. It comes with three detection functions based on its environmental awareness capabilities and has been exhibited at the North American International Auto show 2018, in Detroit.

Called Structural Health and Knock Emission (Shake) sensor, it has been upgraded to recognise structure-borne sound waves generated by contact or knocks on its body through piezoelectric foil sensors.

Shake’s adaptive impact detection uses two sensors on the front and rear of the vehicle to detect slight touches from other cars or pedestrians to its bumper at speeds up to approximately 12mph. It can also trigger a signal to stop vehicles to prevent further damage as well as detecting contact and performing an emergency stop if any collision with obstructions occurs during parking.

The intelligent damage detection identifies the severity as well as the time and place of vehicle damage, including scratches, dents and paint damage.

For more information on companies in this article

Related Content

  • Trials show fuel savings with connected vehicle technology
    December 16, 2015
    American and European trials point to fuel and emissions reductions. A trial by University of California-Riverside (UC-Riverside) has shown connected vehicle technology has the potential to reduce fuel consumption (and therefore emissions) by up to 18% compared with an uninformed driver.
    Read More
  • Toyota proving ground tests co-operative ITS
    February 25, 2013
    Opened in November 2012, Toyota’s intelligent transportation systems (ITS) proving ground is being used to run a number of interactive tests between specially-equipped Toyota vehicles. Located at the company's Higashi-Fuji Technical Centre in Susono City, Japan, the ITS proving ground is a 3.5-hectare site that faithfully replicates a real urban environment, complete with intersecting streets, pedestrian crosswalks, and traffic signals. It is equipped with optical beacons, government-allocated 760 MHz trans
    Read More
  • Autonomous vehicles will not prevent half of real-world crashes
    April 5, 2017
    Alan Thomas of CAVT looks at the reality behind the safety claims fuelling the drive towards autonomous vehicles
    Read More
  • Daimler’s double take sees machine vision move in-vehicle
    December 13, 2013
    Jason Barnes looks at Daimler’s Intelligent Drive programme to consider how machine vision has advanced the state of the art of vision-based in-vehicle systems. Traditionally, radar was the in-vehicle Driver Assistance System (DAS) technology of choice, particularly for applications such as adaptive cruise control and pre-crash warning generation. Although vision-based technology has made greater inroads more recently, it is not a case of ‘one sensor wins’. Radar and vision are complementary and redundancy
    Read More

Highlighted Content