DynaRoads’s DynaWall raises the moveable barrier game

DynaWall is, literally, a dynamic wall, or barrier in this case. DynaWall’s main application is for use during road construction where it can assist in traffic management by shifting traffic lane barriers. The system can move up to 1,000m of safety barriers within minutes without the need of heavy duty equipment.
April 6, 2016 Read time: 1 min
Hermann Wenger of DynaRoads
DynaWall is, literally, a dynamic wall, or barrier in this case.

DynaWall’s main application is for use during road construction where it can assist in traffic management by shifting traffic lane barriers. The system can move up to 1,000m of safety barriers within minutes without the need of heavy duty equipment.


The system’s manufacturer, Swiss company 8391 DynaRoads, does not make the barriers. But the system is designed to be flexible enough to be used with the majority of barrier types, says Cindy Duerst, who handles international sales.

The method to move the wall – any kind of temporary safety guard barrier – is an electro-hydraulic powered retractable and folding chassis. Essentially, this is a series of small self-crawling wheeled units installed every 10-20m underneath the barrier. Each unit is powered by a 24V rechargeable battery pack.

A hand-held control unit simply plugs into the side of the barrier in order to send messages to the unit to raise the barrier off the ground and then travel in a particular direction.

Related Content

  • May 31, 2013
    Connected cones make for safer sites
    David Crawford welcomes new lives for old road safety products. Traffic cones and barrels have traditionally been on the bottom shelf of the road construction and maintenance industry, typically forming visible soft safety barriers for temporary works at a lower cost than concrete alternatives. On both sides of the Atlantic, however, they are fast gaining new roles as instrumented components in advanced construction safety arrays. The EC-sponsored €1 million (US$1.31 million) Safelane collaborative innovati
    Read More
  • December 13, 2013
    Daimler’s double take sees machine vision move in-vehicle
    Jason Barnes looks at Daimler’s Intelligent Drive programme to consider how machine vision has advanced the state of the art of vision-based in-vehicle systems. Traditionally, radar was the in-vehicle Driver Assistance System (DAS) technology of choice, particularly for applications such as adaptive cruise control and pre-crash warning generation. Although vision-based technology has made greater inroads more recently, it is not a case of ‘one sensor wins’. Radar and vision are complementary and redundancy
    Read More
  • October 27, 2016
    The downside of driverless vehicles
    Driverless cars will have a detrimental effect on congestion and security while the road safety benefits can be achieved sooner and cheaper using ADAS, argues Colin Sowman. Many Governments are consulting about the introduction of driverless vehicles and even running trials. As 70% or 80% of crashes are caused by human error, the promise of a crash-free future of driverless, self-driving or autonomous vehicles (call them what you will) is alluring, as are the claims of reduced congestion and lower emissions
    Read More
  • May 25, 2016
    On a WIM – a global view of weigh in motion
    Q-Free’s Andrew Lees looks at regional characteristics and technology trends in the global Weigh-In-Motion market. The principles of Weigh-In-Motion (WIM) are well established. Data derived from vehicles passing over in-ground sensors can be interpreted for vehicle classification (axle counts and spacing) and positive identification (especially when linked to image capture) applications as well as to derive individual axle and gross vehicle weight (GVW).
    Read More

Highlighted Content