CA Traffic displays BlackCAT Traffic Monitor

At CA Traffic cycle detection has always had a strong focus as visitors to the company’s stand here at Intertraffic will see. As CA Traffic points out, the increase in cycle safety projects has led to new developments and advanced hardware deployment utilising multiple detection technologies for a vast number of scenarios. The BlackCAT Traffic Monitor uses inductive loop technology to provide cycle detection at permanent sites. In its simplest form this allows bicycles to be detected and reported historical
April 5, 2016 Read time: 2 mins
Kyranjeet Sanghera of CA Traffic

At 521 CA Traffic cycle detection has always had a strong focus as visitors to the company’s stand here at Intertraffic will see. As CA Traffic points out, the increase in cycle safety projects has led to new developments and advanced hardware deployment utilising multiple detection technologies for a vast number of scenarios.

The BlackCAT Traffic Monitor uses inductive loop technology to provide cycle detection at permanent sites. In its simplest form this allows bicycles to be detected and reported historically or in real time over GSM/GPRS/3G. Furthermore, the BlackCAT offers direct outputs via an optional switch card to trigger variable message signs at the roadside to alert motorists of nearby cycle traffic. In addition, BlackCAT devices can also be used to monitor both vehicles in roads and cycles on an adjacent cycle lane at the same time.

In addition to all this, new radar technology has been utilised to allow the detection of cycles on dedicated cycle paths, eliminating the need to install in-ground sensors. As well as for battery powered temporary surveys, a solar/mains solution with GPRS communications is available to make this a viable permanent detection method.

At the other end of the scale is the tried and tested pneumatic tube event vehicle recorder (EVR). By deploying pneumatic tubes on a road or cycle path, axle hits are recorded and the data processed by analysis software. Cycles are detected alongside vehicles to a very high accuracy. These robust units are housed within a weatherproof case and offer sustained operation on a single battery for one year.

For more information on companies in this article

Related Content

  • Osprey pumps £75m into EV infrastructure
    September 17, 2021
    Each charger is expected to add 100 miles of range in as little as 10 minutes
    Read More
  • Image Sensing Systems offers accurate Bluetooth vehicle detection
    November 13, 2015
    Image Sensing Systems’ RTMS Sx-300 is a small roadside pole-mounted radar operating in the microwave band. It combines the company’s RTMS radar with a Bluetooth sensor for incident detection, travel time calculation and origin/destination information.
    Read More
  • ITS World Congress debates perceptions of enforcement
    December 4, 2012
    The technical programme of this year’s ITS World Congress in Vienna includes a special session on the image of enforcement. ITS International examines the scale of the problem and what can be done about it. Debate on the merits and difficulties of enforcing speed limits appears centred on a conflict of principles. Put very simply, local communities, people living close to busy or hazardous roads, want to see traffic speeds calmed. Drivers on those roads, on the whole, want their principle of freedom to be m
    Read More
  • FlexMag3 EZ-Out redefines traffic detection installation and flexibility
    March 12, 2024
    Sensys Networks will be demonstrating why it is one of the most innovative companies in ITS, unveiling a new EZ-Out version of its latest generation traffic detection sensor, FlexMag3. Building on the unparalleled durability and rapid deployment capability of FlexMag3, the groundbreaking EZ-Out system makes it possible to swap sensors in seconds.
    Read More

Highlighted Content