Skip to main content

What happens to an electric car in a frontal crash?

At the Detroit Auto Show 2011, Volvo Cars is spotlighting the important issue of electric car safety in an unusual, but distinctive way. On the company's stand there is a Volvo C30 Electric that has undergone a frontal collision test at 40 mph (64 km/h).
January 26, 2012 Read time: 3 mins

At the Detroit Auto Show 2011, 609 Volvo Cars is spotlighting the important issue of electric car safety in an unusual, but distinctive way. On the company's stand there is a Volvo C30 Electric that has undergone a frontal collision test at 40 mph (64 km/h).

"Our tests show it is vital to separate the batteries from the electric car's crumple zones to make it as safe as a conventional car. In Detroit we are the first car maker to show the world what a truly safe electric car looks like after a collision with high-speed impact," says Volvo Cars' president and CEO Stefan Jacoby.

The car on show had a fully charged battery when it was tested at Volvo Cars' crash test laboratory in early December 2010. The crash was a so-called offset collision in which 40 per cent of the front hit a barrier at 40 mph (64 km/h).

"The test produced exactly the results we expected. The C30 Electric offers the very same high safety level as a C30 with a combustion engine. The front deformed and distributed the crash energy as we expected. Both the batteries and the cables that are part of the electric system remained entirely intact after the collision," relates Jan Ivarsson, senior manager Safety Strategy & Requirements at Volvo Cars.

The structure of an electric car differs considerably from that of a conventional car - and the new components pose a number of fresh safety challenges. In order to give the Volvo C30 Electric a range of up to 95 miles (150 km) it is necessary to have a battery pack that weighs about 660 lb (300 kg) and this takes up far more space than a conventional fuel tank. Under the bonnet, the combustion engine has been replaced by a more packaging-efficient and lighter electric motor. What is more, the car has a 400 Volt high-voltage electric system.

"Our far-reaching research emphasises the importance of separating the lithium-ion batteries from the car's crumple zones and the passenger compartment. This is the same safety approach we apply with regard to the fuel tank in a conventional car. Another challenge is to reinforce the crumple zones at the front where the smaller motor occupies less space than usual," says Ivarsson.

In the Volvo C30 Electric the batteries are fitted in the traditional fuel tank position and in the tunnel area. The batteries are robustly encapsulated. Beams and other parts of the car's structure around the battery pack are reinforced. All the cables are shielded for maximum protection.

The crash sensor in the car also controls the fuses - and power is cut in 50 milliseconds in a collision by the same signal that deploys the airbags. The system has several fuses that cut directly if an earth fault is detected, such as a damaged cable coming into contact with the body frame.

In a conventional car, the combustion engine helps distribute the incoming collision forces. In the C30 Electric this task is performed by a reinforced frontal structure that also helps absorb the increased collision energy created as a result of the car's added weight.

For more information on companies in this article

Related Content

  • Volvo to provide EV service at Birmingham airport
    March 26, 2019
    Volvo Bus is to deliver six single-deck electric buses to serve as an environmentally-friendly transport service at Birmingham airport in the UK from October. Nick Barton, CEO at Birmingham Airport, says: “Since 2012 the Airport has reduced its CO2 by 20% per passenger. Implementing the six electric buses will work towards lowering our CO2 per passenger even further.” Volvo says its 7900e vehicles come with an electric motor and four high capacity 200 kWh Lithium-ion batteries, which means no tailpipe em
  • Johnson Controls targets US with battery plant for start-stop vehicle technology
    April 23, 2012
    Johnson Controls has announced plans to invest US$138.5 million to convert its battery plant near Toledo, Ohio, in the US, into an Absorbent Glass Mat (AGM) battery facility for Start-Stop and other high efficiency vehicles. Subject to final state and local incentives, the facility will be the company's first such plant in the United States.
  • ARTBA president: what happened to the hoverboards?
    October 28, 2019
    What keeps Dave Bauer up at night? David Arminas caught up with the head of ARTBA at his Washington, DC office during daylight hours Dave Bauer doesn’t really have many sleepless nights. He might sleep, though, with one eye open, just in case. “We have become a much more divided country politically,” says Bauer, president of ARTBA – American Road and Transportation Builders Association. “Whether you are thinking about federal government, or state or local government, there’s a hostility now in our politi
  • Extended UKAS accreditation for Millbrook’s safety testing
    September 30, 2016
    UK independent vehicle test, validation and engineering services provider Millbrook Group has been awarded an extension certificate for seat belt anchorage and pedestrian impact tests by the UK Accreditation Service (UKAS). This is in addition to the recent commissioning of the roll over and small offset testing facility for full scale crashes. Millbrook’s crash test and safety capabilities include: corkscrew roll over and small-offset testing (opened in Q3 2016); full scale vehicle crash testing to a wi