Skip to main content

Visible road markings: an essential for older drivers and intelligent vehicles

The RAINVISION project, co-financed by the European Commission, recently held its final meeting. Over the past three years, the project has researched the impact of road markings on driver behaviour under different night weather conditions (dry, wet and wet and rainy) and has assessed how different age groups and gender groups adapt their driving based on the above mentioned conditions. The results of the project were presented and in particular, the outcomes of three different trials conducted over the pro
March 20, 2015 Read time: 3 mins
The RAINVISION project, co-financed by the 1690 European Commission, recently held its final meeting. Over the past three years, the project has researched the impact of road markings on driver behaviour under different night weather conditions (dry, wet and wet and rainy) and has assessed how different age groups and gender groups adapt their driving based on the above mentioned conditions.

The results of the project were presented and in particular, the outcomes of three different trials conducted over the project period.

A driving simulator test in France investigated the influence of road markings on drivers’ errors (involuntary run-off-the-road and lane departures) under wet and rainy night conditions. On a simulated rural road combining straight sections and curves, 40 per cent less driving errors were observed with wet-night visible road markings compared to standard markings. The biggest gap was observed for elderly drivers.

The results of the second trial, a track test in Austria reinforced these findings and also showed that, under adverse driving conditions, driving task could be performed better when high-performance marking material was used. Older drivers in particular seemed to benefit from wet-night visible markings, as clearness and perceptibility of the driving trajectory increased when such materials were used.

The on-road trials were carried out in the UK in cooperation the city of Durham.  Working with project partners and traffic police, ten high accident sites were identified and high-performance marking materials were applied on these selected locations. The results of the analysis showed that, on average, those high-performance markings did not lead to an increase of speed.  At the same time, accidents had increased over the same period, although an analysis of police records could not link any of the accidents to the presence of better markings.
The meeting also examined how road markings can help maximise the safety benefits of advanced driver assistance systems (ADAS) in the intelligent vehicle.  Systems such as Lane Departure Warning and Lane Keeping Assist, that prevent drivers from head-on collisions and run-off accidents, will become more commonplace in the years to come and in this sense, it is important that markings can remain visible to tap into the significant safety gains that can arise from these new technologies.

Given that reductions in road fatalities become disproportionately harder as the road safety figures improve, all participants agreed that the introduction of ADAS technologies, in cooperation with core infrastructure elements such as road markings, could make a difference in the years to come.  In this sense, there was a consensus on the need for further research in the field, i.e. field operational tests, to better understand how the interaction of infrastructure and ADAS can work optimally to save lives and prevent injuries.

Some initial research work conducted under the auspices of EuroRAP under the Road that Cars can Read initiative found that road markings should have a minimum retroreflectivity of 150 mcd/m2/lux under dry weather conditions (R3) and 35 mcd/m2/lux under wet and rainy conditions, if they are to remain visible for the driver and the intelligent vehicle at all times. In the opinion of ERF, all A-roads within the EU should comply with this specification by March 2018.

Related Content

  • May 11, 2020
    AVs and poor weather – a bad mix
    The US DoT has produced a report on how adverse weather and road conditions will affect automated vehicles – it found inconsistency between different cars with these features which are already on highways and suggests limitations are not yet understood
  • March 30, 2022
    Swarco takes aim at lane markings
    “Lane markings are currently read by two kinds of sensors: camera and lidar. However, road markings lack uniformity. Improving uniformity is a prerequisite to increase the reliability of readings by different types of sensors,” says Harald Mosböck, VP Europe & APMEA (Sales & Contracting) of the Swarco Road Marking Systems Division and VP of the European Road Federation (ERF).
  • September 13, 2022
    Minimum retroreflectivity standards for US
    FHWA changes requirements for minimum levels of retroreflectivity for road markings
  • May 10, 2017
    3M reflect on why CAVs need lines and signs
    Tammy Meehan and Thomas Hedblom of 3M consider the ongoing development of technology needed to introduce connected and autonomous vehicles. The transportation industry is in the midst of the most dramatic shift since Henry Ford introduced horseless carriages. Already we are seeing the increased use of advanced driver assistance systems (ADAS) which, along with the introduction of autonomous vehicles in the next few decades, will bring profound changes to vehicles and the environment in which they operate.