Skip to main content

Vienna’s first electric bus goes into operation

The first electric bus (eBus) to be used in Austria’s capital city of Vienna has been put into service by the municipal transport authority, Wiener Linien, the first operator in Europe to implement and integrate eBuses into scheduled service. Designed and developed by Siemens Rail Systems and bus manufacturer Rampini, the vehicle is the first of twelve with which Wiener Linien intends to move two of the city's bus services to electric power by the summer of 2013. The vehicle’s total energy requirement is st
October 31, 2012 Read time: 2 mins
The first electric bus (eBus) to be used in Austria’s capital city of Vienna has been put into service by the municipal transport authority, 4203 Wiener Linien, the first operator in Europe to implement and integrate eBuses into scheduled service.

Designed and developed by 189 Siemens Rail Systems and bus manufacturer Rampini, the vehicle is the first of twelve with which Wiener Linien intends to move two of the city's bus services to electric power by the summer of 2013.

The vehicle’s total energy requirement is stored in the onboard lithium ferrite battery system, which also supplies the heating and air-conditioning systems.  The battery charger is installed on the bus, which recharges at each bus stop via an elevating, roof-mounted pantograph. Battery capacity is 96 kilowatt hours, and the batteries can be recharged within fifteen minutes, and provide a range of between 120 to 150 km.  Energy regained from braking is regenerated through the three-phase motors, and fed back into the batteries.  The batteries are fully recharged over night when the bus is stationery in the depot.

The compact low-floor bus can carry up to 40 passengers, and its top speed is limited to 62 kilometers per hour. The bus itself does not emit any CO2, and is almost silent. Siemens claims eBuses require 25 percent less energy than petrol or diesel-powered buses, are less expensive to maintain and are completely emission-free in operation.

For more information on companies in this article

Related Content

  • Poterra launches high power interoperable EV charging technology
    May 10, 2018
    Electric vehicle (EV) firm Poterra has released three high-power charging options which it claims will make a completely electric bus fleet in North America more achievable. The new products are intended to be compatible with J1772 CCS plug-in, as well as J3105 inverted and roof-mounted overhead charging systems. The company says the systems are capable of bi-directional, vehicle-to-grid power flow.
  • Sensor solutions cuts maintenance and emissions
    December 8, 2014
    The new raft of sensor technology can provide cost savings as well as additional functionality, as David Crawford discovers. Austria’s third-largest city, Linz, with a population of around 200,000, is recording substantial savings in its urban tram network within 18 months of introducing a new, high-technology approach to its public transport management. Tram, bus and trolleybus operator Linz Linien forms part of city utilities management company Linz AG, which has been carrying out a wide-ranging Smart Cit
  • ABB to deliver fast charging solution to Denmark
    June 1, 2018
    Asea Brown Boveri (ABB) will deliver four electric buses and a fast charger to the city of Aarhus, Denmark, and its bus operator Busselskabet Aarhus Sporveje. The vehicles will replace four diesel buses to combat air pollution and they are expected to be operational by August 2019. ABB’s 300kW OppCharge platform will be located at the end point of the 15km long route of line 13, where the buses will be recharged. OppCharge can power single and double-deck electric buses using a pantograph to connect the
  • World's first eHighway opens in Sweden
    June 22, 2016
    Today sees the opening of the world's first eHighway in Sweden. For the next two years, a Siemens catenary system for trucks will be tested on a two-kilometre stretch of the E16 highway north of Stockholm. The trial will use two diesel hybrid vehicles manufactured by Scania and adapted, in collaboration with Siemens, to operate under the catenary system The core of the system is an intelligent pantograph combined with a hybrid drive system. A sensor system enables the pantograph to connect to and disconn