Skip to main content

Upsala installs Actibump traffic calming

The Swedish city of Uppsala has become the third city in the country to install Edeva’s Actibump in a bid to improve traffic congestion on a busy four-lane road. According to Edeva, its Actibump traffic calming solution creates road safety through greater compliance with speed limits. Actibump is a metal trough six centimetres deep in the road surface, which the developers say is deep enough for drivers to notice, but not so deep as to cause damage to the vehicle. The system utilises a roadside rad
July 31, 2014 Read time: 2 mins
The Swedish city of Uppsala has become the third city in the country to install 5955 Edeva’s Actibump in a bid to improve traffic congestion on a busy four-lane road.

According to Edeva, its Actibump traffic calming solution creates road safety through greater compliance with speed limits.

Actibump is a metal trough six centimetres deep in the road surface, which the developers say is deep enough for drivers to notice, but not so deep as to cause damage to the vehicle.

The system utilises a roadside radar unit to monitor traffic; if a vehicle is exceeding the speed limit, the metal trough is activated and its flat metal plate pivots downwards, exposing an edge that the vehicle bounces over. Vehicles obeying the speed limit pass the barrier unimpeded, helping to maintain a smooth traffic flow.

Uppsala project manager Martin Öberg says: “According to our studies vehicles are travelling 40 per cent too fast on this road. Hopefully we can reduce that figure. Accessibility will be improved for public transport and operation of snow clearing vehicles.

Linköping Municipality has commissioned VTI, the Swedish National Road and Transport Institute, to Actibump on a major road in the city which is used by 5,000 vehicles per day. Municipal traffic engineer Jonas Nygren says, “We got a good result. The average speed on the measured distance has been reduced from 36 to 32 km/h.”

For more information on companies in this article

Related Content

  • University research shows a few self-driving cars can improve traffic flow
    May 15, 2017
    The presence of just a few autonomous vehicles can eliminate the stop-and-go driving of the human drivers in traffic, along with the accident risk and fuel inefficiency it causes, according to new research by the University of Illinois at Urbana-Champaign. Funded by the National Science Foundation’s Cyber-Physical Systems program, the research was led by a multi-disciplinary team of researchers with expertise in traffic flow theory, control theory, robotics, cyber-physical systems, and transportation engine
  • Radar effective as detection tool for hard shoulder running
    July 23, 2012
    Navtech Radar's millimetric-wave systems are being researched on the M42 in England to look into how this type of detector can assist in the opening of the hard shoulder as an additional running lane. Here, the company's Stephen Clark talks about the technology being used. In England, the Highways Agency's (the HA, an executive agency of the Department for Transport) Managed Motorways system - formerly called Active Traffic Management - uses electronic signs and signals mounted on gantries to direct drivers
  • International Road Safety Awards: the winners
    March 4, 2019
    Road accidents are a major blight on the world’s highways - but some companies are attempting to stem the tide. David Arminas reports on the annual Prince Michael International Road Safety Awards
  • Gatso to participate in German average speed pilot
    September 11, 2014
    The idea of average speed enforcement, or section control, in Germany has long been discussed by German authorities following its recommendation in 2009 by the 47th German Traffic Court Day. Interior Minister Boris Pistorius has announced a section control pilot project which is scheduled to be operational in Lower Saxony in spring 2015. Instead measuring speed in the conventional at a single point, section control measures average speed over a longer stretch of road. This method usually results in l