The smart tram, M2M solution for urban transport

A joint pilot project involving Kapsch CarrierCom, Bombardier and Linz AG Linien has demonstrated machine to machine (M2M) communication for use in the urban transport sector. The solution developed by Kapsch was installed in a number of Linz AG Linien trams in collaboration with the manufacturer Bombardier. The trams are equipped with numerous sensors, which measure various parameters. The data is transmitted to the operations control centre in real time and continuously analysed, enabling the tram oper
February 13, 2014 Read time: 2 mins
A joint pilot project involving 81 Kapsch CarrierCom, 513 Bombardier and Linz AG Linien has demonstrated machine to machine (M2M) communication for use in the urban transport sector.

The solution developed by Kapsch was installed in a number of Linz AG Linien trams in collaboration with the manufacturer Bombardier. The trams are equipped with numerous sensors, which measure various parameters. The data is transmitted to the operations control centre in real time and continuously analysed, enabling the tram operator to implement both short- and long-term measures that contribute to a more efficient use of energy, a reduction of the operating costs, and a higher degree of comfort for the passengers.

According to Kapsch CarrierCom, the system is modular and ready to be used by other urban transport organisations, including buses or light rail systems, while Linz AG Linien says that in addition to a reduction in energy costs, the M2M solution provides them with significantly better information about the condition of the vehicles, enabling them to carry out maintenance work in a far more targeted way.

For more information on companies in this article

Related Content

  • System predicts train delays and informs response
    February 25, 2016
    David Crawford looks into the near-term future for Stockholm’s rail commuters. Swedish rail operator Stockholmståg, which runs commuter services in and around the country’s capital, is claiming a world first with the introduction of its automated Pendelprognosen (commuter prognosis) service. Developed to enable the prediction of delays as much as two hours before they are likely to occur, this offers the operator the scope for much earlier remedial action than previously - for example by filling in the expe
    Read More
  • Trials of new technologies to counter age-old work zone challenges
    May 19, 2017
    New solutions are being used to improve the management and safety of work zones on roads both big and small, as Jon Masters discovers. The UK government has recently been going to some lengths to paint a picture of a nation embracing a future of digital technology – understandably given the economic concerns arising from exiting the European Union. In December last year, however, the UK National Infrastructure Commission (NIC) put down a somewhat different marker for where the UK is now in terms of mobile c
    Read More
  • What actually happens if we do #FreetheMIBs?
    May 1, 2020
    Q-Free’s #FREEtheMIBs campaign highlights the use of manufacturer-specific data output, storage and communication protocols in traffic lights and ITS systems.
    Read More
  • UK's first tram train en route to Sheffield
    November 25, 2015
    THE UK’S first tram train vehicle has started its journey to Sheffield from Spain. The fully-constructed, 37m long tram train will make a two week voyage over land and sea from Valencia before arriving in South Yorkshire on 1 December. Passengers in the county will be the first in the UK to benefit from the innovative new tram train, a tram-type vehicle that has the signalling, power supply, control and communication technology to run on both street tram lines and the rail network.
    Read More

Highlighted Content