Skip to main content

Rail industry, regulators debate feasibility of PTC

US rail industry officials and federal accident regulators have disagreed about the viability of a looming mandate that most US railways be equipped with automated control systems by the end of next year. Congress is requiring that most major railroad companies install automated systems known as positive train control (PTC) by December 2015. Automated train systems have gained renewed attention after a spate of high-profile accidents on passenger and freight railways, including most recently a Decem
March 10, 2014 Read time: 3 mins

US rail industry officials and federal accident regulators have disagreed about the viability of a looming mandate that most US railways be equipped with automated control systems by the end of next year.

Congress is requiring that most major railroad companies install automated systems known as positive train control (PTC) by December 2015.

Automated train systems have gained renewed attention after a spate of high-profile accidents on passenger and freight railways, including most recently a December derailment of a freight train in North Dakota that resulted in 400,000 gallons of crude oil being spilled.

The law requiring the implementation of automated train control systems by 2015 has been on the books since 2008.

However, Association of American Railroads President Ed Hemberger told members of the Senate Commerce, Science and Transportation Committee that the automated systems have proven to be more difficult to install than regulators imagined.

"PTC is an unprecedented challenge, both in terms of the technologies to be used and the integration of those technologies," Hemberger told the panel in testimony submitted before Thursday's hearing.

"The railroad industry began working several years ago with the 2115 Federal Communications Commission (FCC) to licence the wireless spectrum necessary for PTC,” he said.  However, under the FCC’s interpretation of Section 106 of the National Historic Preservation Act (NHPA), railroads must ascertain, on an antenna-by-antenna basis, if the antennas will negatively impact areas of historic, cultural, or religious significance.

Hemberger said the railroads were in agreement with federal regulators about the importance of installing automated train control systems to boost safety.  But the rail association chief said the only solution to the challenges facing the train industry was to push back the 2015 deadline for them to automate.

"The bottom line is that without further changes to the FCC approval process, the timeline for ultimate deployment of PTC will be delayed significantly," Hemberger said.

5628 National Transportation Safety Board (NTSB) Vice Chairman Chris Hart said the safety benefits of automating trains should outweigh the rail industry's technical concerns.

"Implementation of PTC systems was included on the NTSB’s Most Wanted List when the list was First published in 1990 and has remained on the list almost continuously since that time," Hart said. "We may never eliminate human error from the railroad system, but PTC provides a level of redundancy to protect trains and those on board when human factors, such as distraction or fatigue, might otherwise set an accident sequence into motion." 

For more information on companies in this article

Related Content

  • Governors urge Congress to act on transportation funding
    January 31, 2014
    The National Transportation Coalition, a US bipartisan group of governors, is calling on Congress to take immediate action to avoid a looming national crisis – the expiration of national highway funding. Seventeen Governors have signed a letter urging congressional members to act and avoid a potential nationwide transportation funding crisis. The Highway Trust Fund, the funding mechanism that drives the US investment in transportation infrastructure, is facing its fifth revenue shortfall since 2008. Mo
  • Groups seek electronic collision alert devices on big trucks
    February 20, 2015
    The US Advocates for Highway and Auto Safety, the Truck Safety Coalition, the Center for Auto Safety and Road Safe America have filed a petition with the National Highway Traffic Safety Administration (NHTSA) requesting that the agency initiate rulemaking to require forward collision avoidance and mitigation braking (F-CAM) systems on all new large trucks and buses with a gross vehicle weight rating (GVWR) of 10,000 pounds or more. F-CAM technology uses radar and sensors to first alert the driver and then t
  • IRD: from the ground up
    September 16, 2021
    IRD is undertaking a comprehensive review of its road safety and monitoring solutions. A series of initiatives is building on the company’s in-pavement expertise, bringing considerable additional value for the customer to the traditional range of products while complementing these with wholly new technologies
  • Asecap Days 2024: Getting used to the new normal
    August 27, 2024
    Asecap Days 2024 in Milan focused on environmental protection of road infrastructure, digital twin-based maintenance and monitoring of highways as well as the impact of electric vehicles, reports David Arminas