Skip to main content

Rail industry, regulators debate feasibility of PTC

US rail industry officials and federal accident regulators have disagreed about the viability of a looming mandate that most US railways be equipped with automated control systems by the end of next year. Congress is requiring that most major railroad companies install automated systems known as positive train control (PTC) by December 2015. Automated train systems have gained renewed attention after a spate of high-profile accidents on passenger and freight railways, including most recently a Decem
March 10, 2014 Read time: 3 mins

US rail industry officials and federal accident regulators have disagreed about the viability of a looming mandate that most US railways be equipped with automated control systems by the end of next year.

Congress is requiring that most major railroad companies install automated systems known as positive train control (PTC) by December 2015.

Automated train systems have gained renewed attention after a spate of high-profile accidents on passenger and freight railways, including most recently a December derailment of a freight train in North Dakota that resulted in 400,000 gallons of crude oil being spilled.

The law requiring the implementation of automated train control systems by 2015 has been on the books since 2008.

However, Association of American Railroads President Ed Hemberger told members of the Senate Commerce, Science and Transportation Committee that the automated systems have proven to be more difficult to install than regulators imagined.

"PTC is an unprecedented challenge, both in terms of the technologies to be used and the integration of those technologies," Hemberger told the panel in testimony submitted before Thursday's hearing.

"The railroad industry began working several years ago with the 2115 Federal Communications Commission (FCC) to licence the wireless spectrum necessary for PTC,” he said.  However, under the FCC’s interpretation of Section 106 of the National Historic Preservation Act (NHPA), railroads must ascertain, on an antenna-by-antenna basis, if the antennas will negatively impact areas of historic, cultural, or religious significance.

Hemberger said the railroads were in agreement with federal regulators about the importance of installing automated train control systems to boost safety.  But the rail association chief said the only solution to the challenges facing the train industry was to push back the 2015 deadline for them to automate.

"The bottom line is that without further changes to the FCC approval process, the timeline for ultimate deployment of PTC will be delayed significantly," Hemberger said.

5628 National Transportation Safety Board (NTSB) Vice Chairman Chris Hart said the safety benefits of automating trains should outweigh the rail industry's technical concerns.

"Implementation of PTC systems was included on the NTSB’s Most Wanted List when the list was First published in 1990 and has remained on the list almost continuously since that time," Hart said. "We may never eliminate human error from the railroad system, but PTC provides a level of redundancy to protect trains and those on board when human factors, such as distraction or fatigue, might otherwise set an accident sequence into motion." 

For more information on companies in this article

Related Content

  • Uber ‘disabled braking system’ in fatal crash
    May 30, 2018
    Uber had disabled the emergency braking function of the Volvo XC90 which killed a pedestrian in Tempe, Arizona in March. A preliminary report from the National Transportation Safety Board (NTSB) says the car was “operating with a self-driving system in computer control mode” when it struck 49-year-old Elaine Herzberg, who was pushing a bicycle across the road. According to the NTSB report, Uber said “emergency braking manoeuvres are not enabled while the vehicle is under computer control, to reduce the
  • IBTTA explains INVEST in America Act 2021
    June 23, 2021
    Mark Muriello, IBTTA director of policy & government affairs, outlines some of the key tolling points of the US House Transportation & Infrastructure Committee’s INVEST in America Act 2021
  • Network Rail successfully tests new trains using advanced ‘in-cab’ signalling system
    August 5, 2016
    An advanced signalling system that will allow trains to travel every two to three minutes through central London was successfully tested using Govia Thameslink Railway’s new Siemens Class 700 trains for the first time. The Thameslink Programme, part of Network Rail’s Railway Upgrade Plan to provide a bigger, better, more reliable railway for passengers and businesses, achieved another milestone in the early hours of Saturday morning as it successfully ran a Class 700 train through the central London ‘cor
  • Trends in automotive technology
    March 14, 2012
    Continental has become a leading player in vehicle technology and telematics. The firm’s executive board chairman Elmar Degenhart describes to Jason Barnes Continental’s views on the ‘megatrends’ of the automotive industry Strategic moves to diversify Continental’s business from rubber-related products began in the late 1990s with the acquisition of ITT Teves and its brake business. This brought on board know-how relating to the then new electronic stability control (ESC) systems which today form an import