Skip to main content

Rail industry, regulators debate feasibility of PTC

US rail industry officials and federal accident regulators have disagreed about the viability of a looming mandate that most US railways be equipped with automated control systems by the end of next year. Congress is requiring that most major railroad companies install automated systems known as positive train control (PTC) by December 2015. Automated train systems have gained renewed attention after a spate of high-profile accidents on passenger and freight railways, including most recently a Decem
March 10, 2014 Read time: 3 mins

US rail industry officials and federal accident regulators have disagreed about the viability of a looming mandate that most US railways be equipped with automated control systems by the end of next year.

Congress is requiring that most major railroad companies install automated systems known as positive train control (PTC) by December 2015.

Automated train systems have gained renewed attention after a spate of high-profile accidents on passenger and freight railways, including most recently a December derailment of a freight train in North Dakota that resulted in 400,000 gallons of crude oil being spilled.

The law requiring the implementation of automated train control systems by 2015 has been on the books since 2008.

However, Association of American Railroads President Ed Hemberger told members of the Senate Commerce, Science and Transportation Committee that the automated systems have proven to be more difficult to install than regulators imagined.

"PTC is an unprecedented challenge, both in terms of the technologies to be used and the integration of those technologies," Hemberger told the panel in testimony submitted before Thursday's hearing.

"The railroad industry began working several years ago with the 2115 Federal Communications Commission (FCC) to licence the wireless spectrum necessary for PTC,” he said.  However, under the FCC’s interpretation of Section 106 of the National Historic Preservation Act (NHPA), railroads must ascertain, on an antenna-by-antenna basis, if the antennas will negatively impact areas of historic, cultural, or religious significance.

Hemberger said the railroads were in agreement with federal regulators about the importance of installing automated train control systems to boost safety.  But the rail association chief said the only solution to the challenges facing the train industry was to push back the 2015 deadline for them to automate.

"The bottom line is that without further changes to the FCC approval process, the timeline for ultimate deployment of PTC will be delayed significantly," Hemberger said.

5628 National Transportation Safety Board (NTSB) Vice Chairman Chris Hart said the safety benefits of automating trains should outweigh the rail industry's technical concerns.

"Implementation of PTC systems was included on the NTSB’s Most Wanted List when the list was First published in 1990 and has remained on the list almost continuously since that time," Hart said. "We may never eliminate human error from the railroad system, but PTC provides a level of redundancy to protect trains and those on board when human factors, such as distraction or fatigue, might otherwise set an accident sequence into motion." 

For more information on companies in this article

Related Content

  • C-ITS in Europe: jazz or symphony?
    August 18, 2021
    Communication between vehicles on the road is going to be increasingly important. Richard Lax of Kapsch TrafficCom explains why music is a good guide to the way that this could work safely
  • Rail Summit to discuss automated operations in Aviation and Rail, Vienna
    October 4, 2017
    The often repeated comparison between the levels of automation in the aviation and rail sectors will come under scrutiny at the Intelligent Rail Summit Vienna 28 – 30 November, according to a report in rail knowledge sharing platform Railtech.com. Dick Terleth, director mobility at ADSE consulting and avionics specialist Sander Van Lochem, will discuss automated operations and focus on the introduction, operation and lifecycle
  • Sound synthesis makes hybrid and electric vehicles safer
    January 20, 2012
    The growing popularity of hybrids and electric vehicles gives rise to new safety issues in urban environments, as many of the aural cues associated with engine noise can be missing. The solution is to intelligently make vehicles noisier. The rise in popularity of hybrids and Electric Vehicles (EVs) is a result of environmental pressures, shifts in taxation and emerging technologies for batteries and motors. Competition among the car manufacturers means these vehicles need to be cost effective to buy and ope
  • Applied Info to buy back DSRC roadside kit
    November 20, 2020
    Applied Information makes offer following US regulator's decision on 5.9 GHz safety spectrum