Skip to main content

Qualcomm partnership demonstrates dynamic electric vehicle charging

Qualcomm Technologies, in partnership with Renault and Vedecom, has demonstrated dynamic wireless electric vehicle charging (DEVC), based on its Halo wireless electric vehicle charging technology (WEVC), to enable electric vehicles to charge dynamically at up to 20 kilowatts at highway speeds.
May 22, 2017 Read time: 2 mins
213 Qualcomm Technologies, in partnership with Renault and Vedecom, has demonstrated dynamic wireless electric vehicle charging (DEVC), based on its Halo wireless electric vehicle charging technology (WEVC), to enable electric vehicles to charge dynamically at up to 20 kilowatts at highway speeds.


Qualcomm Technologies also demonstrated simultaneous charging, in which two vehicles on the same track can charge dynamically at the same time, picking up charge in both directions along the track and in reverse.

The charging demonstrations took place at the 100-metre test track built by Vedecom at Satory Versailles, France, as part of the EU FABRIC project, which is looking at the viability of wireless DEVC.

Qualcomm Technologies and Vedecom integrated the transmission source portion of the Qualcomm Halo DEVC system into the test track, while Vedecom and Renault integrated the receiving portion into two Renault Kangoo vehicles.

Following the demonstration, the Qualcomm Halo DEVC system will be handed over to Vedecom to perform tests for FABRIC. These tests will evaluate the operation, safety and efficiency of energy transfer to the vehicles for a wide range of practical scenarios including vehicle identification and authorisation on entering the track, power level agreement between track and vehicle, speed and alignment of the vehicle along the track.

Related Content

  • November 9, 2017
    Mobinet counters weighty cross border concerns
    A Mobinet pilot is combining onboard weighing with V2X comms to streamline vehicle weight enforcement. David Crawford reports. Pan-European, cross-border weigh-in-motion (WIM) for trucks is now a practical possibility, following successful Scandinavian trials within the EU-co-funded Mobinet (Internet of Mobility) programme. New technology is using strain sensors, located on load-bearing components and routinely installed in truck fleet management systems.
  • January 31, 2012
    In-vehicle intersection violation Warning system
    Mike Schagrin, ITS Joint Program Office, RITA, and John Harding, NHTSA, describe US progress towards an in-vehicle Intersection Violation Warning system. In 2008, there were 37,261 fatalities on US roadways. Of these, 7,772, some 20.8 per cent of the total, were defined as intersection crashes or intersection-related crashes. Through a multi-agency research initiative led by the Research and Innovative Technology Administration (RITA), the US Department of Transportation (USDOT) has developed a prototype In
  • October 24, 2014
    Workzone safety can be economically viable
    David Crawford looks how workzone safety can be ‘economically viable’. Highway maintenance is one of the most dangerous construction industry occupations in Europe. Research from The Netherlands on fatal crashes indicates that the risk facing road workzone operatives is ‘significantly higher’ than that for the general construction workforce. A survey carried out by the Highways Agency, which runs the UK’s motorway and trunk road network, has suggested that 20% of road workers have suffered injuries from pa
  • May 28, 2014
    Smoothing out city freight movements
    David Crawford welcomes a national first. Urban freight movements, while commercially and socially vital, are a growing logistical headache for planners and people alike. Figures from France’s Lyon Laboratory of Transport Economics indicate that goods transport in major urban areas accounts for: 20% of traffic; 35% of CO2 emissions made by all urban trips; and 50% of the diesel used; while final km delivery runs account for 20% of the total cost of the transport chain.