Skip to main content

Overhaul of driver and motorcycle training welcomed by IAM RoadSmart

Leading UK road safety charity IAM RoadSmart has welcomed Government plans to improve driver and motorcycling training. The plans include learner drivers being allowed on motorways for the first time, novice riders required to complete a theory test as part of their Compulsory Basic Training (CBT) and provisional motorcyclists to be banned after receiving six penalty points. The Government says the changes will see competent learner drivers able to have lessons on motorways with an approved driving i
January 3, 2017 Read time: 2 mins
Leading UK road safety charity IAM RoadSmart has welcomed Government plans to improve driver and motorcycling training.

The plans include learner drivers being allowed on motorways for the first time, novice riders required to complete a theory test as part of their Compulsory Basic Training (CBT) and provisional motorcyclists to be banned after receiving six penalty points.

The Government says the changes will see competent learner drivers able to have lessons on motorways with an approved driving instructor in a dual controlled car.

In addition the CBT course, which allows motorcyclists to ride unaccompanied on Great Britain’s roads, will also be updated.

Neil Greig, director of policy and research, said: “It makes no sense that new drivers learn by trial and, often fatal, error how to use our fastest and most important roads.  Allowing learners on motorways with an approved instructor is a sensible and measured solution that should deliver drivers who are much better able to cope with complex new smart motorways.”

On the changes to motorcycle training, he said the proposals close two loopholes that IAM RoadSmart has been highlighting with motorcycle industry training partners.  He said, “A theory test should always be the first step for any motorised road user before they reach the road.  The six penalty point approach also finally brings motorcycle users in line with the New Driver’s Act for car drivers.”

The 1837 Department for Transport and the Driver and Vehicle Standards Agency have jointly launched consultations seeking views, which will run until 17 February 2017. The changes could take effect by 2018.

Related Content

  • April 9, 2014
    ITS homes in on cycling safety
    A new generation of ITS equipment is helping road authorities get to grips with cycle safety – and not a moment too soon as Colin Sowman discovers. Cyclists - remember them? Apparently not. At least not according to the OECD 2013 report Cycling, Health and Safety which contains the statement: ‘Cyclists are often forgotten in the design of the road traffic system’. Looking through the statistics that exist (each country appears to compile them differently) it is not difficult to see how such a conclusion cou
  • April 5, 2017
    Autonomous vehicles will not prevent half of real-world crashes
    Alan Thomas of CAVT looks at the reality behind the safety claims fuelling the drive towards autonomous vehicles
  • February 2, 2012
    Need for performance standards for road user charging systems
    GNSS-based road use metering systems need performance metrics, as well as ways to test and reliably compare them. Bern Grush and Joaquín Cosmen write about the function of the GNSS Metering Association for Road-use charging (GMAR), recently set up to address this issue
  • May 13, 2016
    Australia’s laws are ‘not ready for driverless vehicles’
    Australia’s National Transport Commission (NTC) has released Regulatory Options for Automated Vehicles, a discussion paper that finds a number of legislative barriers to increasing vehicle automation. The paper proposes that there are barriers that need to be addressed as soon as possible to ensure clarity around the status of more automated vehicles on Australia’s roads and to support further trials. In the longer term other legislative barriers will need to be addressed to allow fully driverless vehic