Marwis mobile road sensor on display by Lufft

German measurement technology specialist, G. Lufft is here at the ITS World Congress with a clear message: although stationary road weather information sensors have been in use for many years, even the densest RWIS network can’t cover what Marwis, the innovative mobile road sensor, is capable of.
October 6, 2015 Read time: 2 mins
Nouredine Hafsaoui of Lufft with the mobile weather sensor

German measurement technology specialist, G. 6478 Lufft is here at the ITS World Congress with a clear message: although stationary road weather information sensors have been in use for many years, even the densest RWIS network can’t cover what Marwis, the innovative mobile road sensor, is capable of.

Marwis transforms vehicles into mobile weather stations and delivers data in high-speed. This enables winter service vehicles, school buses, airports and potentially every driver to enhance safety and get reliable information on different surfaces. The sensor detects water film on the road, ice percentage, road status, friction, temperatures and more, providing total control over a route, in terms of safety and of time.

The measuring principle of Marwis is based on the principle of the NIRS31, introduced in 2011. Since then it has also been offered in the embedded passive IRS31-UMB and the active ARS31Pro-UMB sensor. The NIRS31-UMB was the first contactless road weather sensor from Lufft capable of analysing the road below safely from a distance of up to 16 metres. As the company points out, this is especially useful for bridges where the road surface temperatures are cooler than the adjoining road surface and invasive systems require installation bases that are too deep.

“The perfect supplement for our mobile road sensors is our WS700-UMB multifunction weather sensor because it addresses so many needs within one casing,” says Nouredine Hafsaoui. “As visitors to our stand will see, it requires only one cable connection and combines sensors for the detection of air temperature, relative humidity, precipitation intensity and type, air pressure, wind direction, wind velocity and global radiation."

For more information on companies in this article

Related Content

  • Is DSRC progressive enough for future connected mobility?
    February 3, 2012
    Dedicated Short Range Communications technology, says Cisco's Paul Brubaker, is not by itself progressive enough to sustain long-term innovation in the connected mobility environment - and yet IPv6 and other developments remain largely ignored by policy-makers
    Read More
  • Increased automation is already improving road safety
    April 20, 2017
    Richard Cuerden considers how many of the technologies developed as part of a move toward autonomous vehicles are already being deployed as ADAS improve road safety. The drive to create autonomous vehicles has caused a re-evaluation of what is needed to safely navigate today’s roads and the development of systems that can replace the driver in many scenarios. However, many manufacturers are not waiting for ‘tomorrow’ and are already incorporating these systems in their new cars as Advanced Driver Assistanc
    Read More
  • Sony’s vision systems help limit risk in road tunnels
    November 10, 2017
    Sony’s Stephane Clauss looks at the imaging requirements in tunnels. In the event of a fire inside a tunnel, the dispersion of gases and heat is prevented, creating extreme temperatures that have led to many deaths. Following tragic incidents including Mont Blanc, European legislation requires longer tunnels to be fitted with incident and smoke detection systems.
    Read More
  • After two decades of research, ITS is getting into its stride
    June 4, 2015
    Colin Sowman gets the global view on how ITS has shaped the way we travel today and what will shape the way we travel tomorrow. Over the past two decades the scope and spread of intelligent transport systems has grown and diversified to encompass all modes of travel while at the same time integrating and consolidating. Two decades ago the idea of detecting cyclists or pedestrians may have been considered impossible and why would you want to do that anyway? Today cyclists can account for a significant propor
    Read More

Highlighted Content