J-J Hooks barrier system passes demanding crash tests

Easi-Set Worldwide has announced that its J-J Hooks barrier system has successfully passed both bolted-down and pinned-down MASH Test Level 3 crash tests (MASH - Manual for Assessing Safety Hardware), out-performing other comparable systems. The tests were performed by the Texas Transportation Institute.
June 19, 2012 Read time: 1 min
5948 Easi-Set Worldwide has announced that its J-J Hooks barrier system has successfully passed both bolted-down and pinned-down MASH Test Level 3 crash tests (MASH - Manual for Assessing Safety Hardware), out-performing other comparable systems. The tests were performed by the 232 Texas Transportation Institute.

Prior to these tests, over 41 states/provinces and eight countries have approved the free-standing J-J Hooks temporary barrier for use on their highways. This temporary barrier successfully passed NCHRP 350 TL3 tests in the 1990’s, qualifying it for approval as an alternate to existing state/provincial standard barrier designs. Easi-Set is identifying this barrier as J-J Hooks/NCHRP.

The anchored J-J Hooks design, dubbed J-J Hooks/MASH, incorporates an enlarged J-Hook, additional reinforcing to absorb the higher impact loads, and patented deflection limiting blocks.

Both designs connect seamlessly to each other and they can be placed in the same installation without the need for a transition section. This allows one installation to satisfy up to three different performance requirements. Both J-J Hooks designs are available in cross-sections commonly used on existing highways.

For more information on companies in this article

Related Content

  • New system expedites border crossings
    October 28, 2016
    Enforcing border controls can create long queues for travellers, David Crawford looks at potential solutions. Long delays at border crossings in both North America and Europe have sparked the development of new queue visualisation and management technologies that are cutting hours, even days, off international passenger and freight journeys. At the westernmost end of the 2,019km (1,250 mile) Mexico–US frontier, two parallel crossings between Tijuana, in the former country, and the border city of San Diego,
    Read More
  • Commercial Vehicle Operations in New Brunswick
    July 16, 2012
    The Province of New Brunswick has prepared a deployment plan for ITS applications for Commercial Vehicle Operations (CVO). The plan, developed by Delcan Corporation, identifies a number of potential ITS/CVO investments and initiatives to be implemented. One of the initiatives is the Motor Carrier Profile (MCP), which has been selected as one of the sample projects for the application of the Project Evaluation Methodology Framework for Canadian ITS.
    Read More
  • Transportation applications move to machine vision’s mainstream
    June 11, 2015
    The adaptation of machine vision to transport applications continues apace. That the machine vision industry is taking traffic installations seriously is evident by the amount of hardware and software products tailor-made for ITS applications that are now available on the market. A good example comes from US-based Gridsmart Technologies which has developed a single wire fisheye camera that provides a horizon to horizon view for use at intersections. Not only does the single camera replace four or more in a
    Read More
  • TfL trials cyclist detection
    June 5, 2015
    New world first trials would allow TfL to better cater for cyclists at key junctions Further on-street trials will take place later this year TfL now given blanket approval from DfT to install low-level cycle signals at junctions Transport for London (TfL) is to trial a new technology that will help give cyclists more time on green lights.
    Read More

Highlighted Content