J-J Hooks barrier system passes demanding crash tests

Easi-Set Worldwide has announced that its J-J Hooks barrier system has successfully passed both bolted-down and pinned-down MASH Test Level 3 crash tests (MASH - Manual for Assessing Safety Hardware), out-performing other comparable systems. The tests were performed by the Texas Transportation Institute.
June 19, 2012 Read time: 1 min
5948 Easi-Set Worldwide has announced that its J-J Hooks barrier system has successfully passed both bolted-down and pinned-down MASH Test Level 3 crash tests (MASH - Manual for Assessing Safety Hardware), out-performing other comparable systems. The tests were performed by the 232 Texas Transportation Institute.

Prior to these tests, over 41 states/provinces and eight countries have approved the free-standing J-J Hooks temporary barrier for use on their highways. This temporary barrier successfully passed NCHRP 350 TL3 tests in the 1990’s, qualifying it for approval as an alternate to existing state/provincial standard barrier designs. Easi-Set is identifying this barrier as J-J Hooks/NCHRP.

The anchored J-J Hooks design, dubbed J-J Hooks/MASH, incorporates an enlarged J-Hook, additional reinforcing to absorb the higher impact loads, and patented deflection limiting blocks.

Both designs connect seamlessly to each other and they can be placed in the same installation without the need for a transition section. This allows one installation to satisfy up to three different performance requirements. Both J-J Hooks designs are available in cross-sections commonly used on existing highways.

For more information on companies in this article

Related Content

  • ITS adaptions enhance cycle safety in Dublin
    December 3, 2013
    Enabled and enforced by innovative use of ITS, Dublin’s new off-road cycle route is proving a hit with commuters, leisure cyclists and walkers alike as Brendan O’Brien explains. Dublin City Council’s vision is to create a city where people of all ages and abilities have the confidence, incentive and facilities to cycle. On-road cycle lanes had already been incorporated into the Quality Bus Corridors design and there is a mix of on- and off-road cycle routes. However, in 2010 the Council began work on a new
    Read More
  • Virtual surveying boosts efficiency in Utah DOT
    June 12, 2015
    Overlaying a geographic information system with data from a new surveying system is paying dividends for Utah DOT. While building new roads tramways, metros and bicycle paths or installing smart systems to control traffic is the high-profile end of transportation planning and management, ensuring existing infrastructure and systems are serviceable and working is arguably more important. After all, at any given point the existing infrastructure will always carry more vehicles than new.
    Read More
  • Freight poses growing problem for city authorities
    March 3, 2017
    Wes Guckert considers possible solutions and countermeasures to the problems of increased freight deliveries in growing cities. In January 2016, the US Department of Transportation (USDoT) conducted a session on the SmartCity Challenge and Urban Freight and Logistics. This session was a follow-up to the USDoT report titled, Beyond Traffic 2045.
    Read More
  • Kapsch ‘opens the way’ to interoperability
    July 30, 2013
    Richard Turnock, chief technology officer of Kapsch TrafficCom North America explains what advantages its newly-opened TDM protocol can offer as a US-wide standard for tolling interoperability. The electronic tolling industry across the United States is evolving. Historically it was characterised by clusters of interoperability where a motorist may be able to use the same transponder across a large area, such as the 15-State E-ZPass system, or be confined to a single State system. Now, however, the industry
    Read More

Highlighted Content