Skip to main content

High-tech road studs can help tackle accident trend

According to road safety engineer Alan Vass of the Traffic and Road Safety section of Ayrshire Roads Alliance in Scotland, LED road studs have contributed to a 100 per cent reduction in incidents on a stretch of the A719 road in the county. Vass says the active studs, which use LED and solar technology to create delineation shown to be far more effective than traditional retro-reflective studs, could hold the key to a brighter future. He said: “There had been a number of accidents on the A719 near Wat
October 3, 2014 Read time: 2 mins
According to road safety engineer Alan Vass of the Traffic and Road Safety section of Ayrshire Roads Alliance in Scotland, LED road studs have contributed to a 100 per cent reduction in incidents on a stretch of the A719 road in the county.

Vass says the active studs, which use LED and solar technology to create delineation shown to be far more effective than traditional retro-reflective studs, could hold the key to a brighter future.

He said: “There had been a number of accidents on the A719 near Waterside village in Ayrshire and the council wanted to do all they could to address the issue.

“The road is predominantly straight but also has a series of fairly sharp bends and we were keen to enhance safety whilst limiting impact on the environment in a rural area.

“We installed LED active studs and statistics prove we’ve seen dramatic results.

“I think it won’t be long before other authorities look at what East Ayrshire Council has done and realise the technology could have similar positive implications for them.”

Supplied by Rennicks UK, some 180 of the solar-recharged battery-powered SR-15 Active Road Studs were installed, providing bright delineation and advance warning of bends. The units, which contain two bi-directional LEDs, highlight both the horizontal and vertical geometry of the road and help improve visibility of the centre and carriageway edges, while a rumble effect warns drivers who encroach on to the opposite carriageway.

Studies showed four injury accidents on the major semi-rural road in just three years prior to the studs being installed and there have been no reported incidents since.

Vass added: “It’s clear the scheme contributed towards a fantastic reduction in the number of reported injury accidents and the site continues to perform well in all weather conditions.

“The studs remain bright and clearly highlight each lane, enhancing safety by aiding night-time driving and particularly during rainy, snowy or foggy weather.

“Ayrshire Roads Alliance has received very positive feedback from local residents and commuters and the studs will without doubt be considered for future road safety schemes.”

Related Content

  • Independent analysis finds speed cameras do not reduce accidents
    June 10, 2014
    An independent analysis carried out by engineer Dave Finney of Thames Valley, UK speed camera data has found an increase in injuries after the devices were installed. The analysis, to evaluate the effect of fixed speed cameras on the number and severity of collisions at the sites where they are installed, was carried out on two groups of sites. One group includes all fixed speed camera sites in the Thames Valley area (covering Oxfordshire, Buckinghamshire and Berkshire) that were active at the start of 2
  • Developments in signal head lens technology
    February 3, 2012
    Heads and tails Leading manufacturers of traffic signal systems discuss developments in signal head technology as well as some of the legacy issues which affect future deployments Transparent model of Dambach's ACTROS.line technology, showing the bus electronics in the signal head Cowls could be superseded by the greater use of lens technology
  • Bluetooth and Wi-Fi offer new options for travel time measurements
    November 20, 2013
    New trials show Bluetooth and Wi-Fi signals can be reliably used for measuring travel times and at a lower cost than an ANPR system, but which is the better proposition depends on many factors. Measuring travel times has traditionally relied automatic number plate (or licence plate) recognition (ANPR/ALPR) cameras capturing the progress of vehicles travelling along a pre-defined route. Such systems also have the benefit of being able to count passing traffic and have become a vital tool in dealing with c
  • Plug and play approach unifies workzone ITS
    July 18, 2012
    Caltrans District 7 is finalising a ConOps document which will detail a plug-and-play to work zone ITS operation. The organisation's Allen Z. Chen elaborates. Before August is out, on current planning, the California Department of Transportation (Caltrans) District 7 (which covers Los Angeles and Ventura Counties, with a combined population of close to 11 million people) intends to have finalised a Concept of Operations (ConOps) document dealing with Work Zone Transportation Management Systems (WZTMS). The