Skip to main content

Ficosa shows off new e-mobility development centre

Spanish firm Ficosa has pulled back the curtain on its new centre for developing electromobility solutions. The €10 million, 1,200-m2 ‘e-mobility hub’ near Barcelona in Spain, currently contains four new labs and will be the location for developing and manufacturing software and hardware solutions for hybrid and electric vehicles, specifically battery-management systems and on-board chargers. It is home to 120 engineers, and the company says it will take on 100 more in 2019, as well as adding a new
October 11, 2018 Read time: 2 mins

Spanish firm Ficosa has pulled back the curtain on its new centre for developing electromobility solutions.

The €10 million, 1,200-m2 ‘e-mobility hub’ near Barcelona in Spain, currently contains four new labs and will be the location for developing and manufacturing software and hardware solutions for hybrid and electric vehicles, specifically battery-management systems and on-board chargers.

It is home to 120 engineers, and the company says it will take on 100 more in 2019, as well as adding a new laboratory, increasing the hub’s footprint by 750 m2.

Ficosa CEO Javier Pujol called it a “huge milestone” for the company: “It puts us on the leading edge of the revolution that electric mobility is bringing about in the sector with a cutting-edge centre at a global level.”

The company also has hubs for connectivity and safety at the same location in Viladecavalls. “The Viladecavalls centre has positioned itself as one of the most cutting-edge in the world in vision, e-mobility, connectivity and safety technology, and is, without a doubt, the driving force for the whole technological transformation Ficosa has undergone in recent years,” Pujol adds.

Earlier this year, Ficosa became part of a major Panasonic project to bring cellular-vehicle-to-everything (C-V2X) technologies to Colorado, supplying C-V2X on-board units.

A fleet of Ford utility vehicles is equipped with C-V2X devices that utilise Ficosa’s CarCom platform to enable vehicle-to-vehicle and vehicle-to-infrastructure direct communications.

Related Content

  • High-tech road studs can help tackle accident trend
    October 3, 2014
    According to road safety engineer Alan Vass of the Traffic and Road Safety section of Ayrshire Roads Alliance in Scotland, LED road studs have contributed to a 100 per cent reduction in incidents on a stretch of the A719 road in the county. Vass says the active studs, which use LED and solar technology to create delineation shown to be far more effective than traditional retro-reflective studs, could hold the key to a brighter future. He said: “There had been a number of accidents on the A719 near Wat
  • Lawmakers must ensure we don’t end up with communications breakdown
    May 10, 2019
    5G – or not 5G? That, with apologies to Hamlet, is the question. It’s a vital one for the future of ITS development, particularly in the area of connected and autonomous vehicles (C/AVs). Just a few years ago, there was only one solution in terms of communications protocols for delivering vehicle connectivity – logically, it would have to be based on dedicated short-range communication. Now, road operators and vehicle manufacturers have choices. We examine some of these in ‘The numbers game’ (p28). Su
  • Audi C-V2X tech to improve school safety
    April 8, 2021
    Georgia deployment to gain insight over distance needed around school zones and buses
  • Refurbishing ageing VMS with new technology
    January 26, 2012
    Virginia DoT faced a challenge common to many highway authorities around the world: the need, in economically challenging times, to replace ageing variable message signs reaching the end of their operational life. For some 25 years now, since the mid 80s, Virginia Department of Transportation (VDoT), has deployed variable message signs (VMS) as part of its motorist information systems. Throughout the state there are still many old 'flip-disk' signs. Some of the companies that provided these electronic messa