Cost-effective driver drowsiness detection

Bosch has revealed that its driver drowsiness detection system, first introduced as a standard feature in 2010, in the new Volkswagen Passat is being fitted to the new Passat Alltrack. Fatigue and microsleep at the wheel are often the cause of serious accidents. However, the initial signs of fatigue can be detected before a critical situation arises, and the Bosch system can do this by monitoring steering movements and advising drivers to take a break in time. The required information is provided either by
May 2, 2012 Read time: 3 mins
311 Bosch has revealed that its driver drowsiness detection system, first introduced as a standard feature in 2010, in the new 994 Volkswagen Passat is being fitted to the new Passat Alltrack.

Fatigue and microsleep at the wheel are often the cause of serious accidents. However, the initial signs of fatigue can be detected before a critical situation arises, and the Bosch system can do this by monitoring steering movements and advising drivers to take a break in time. The required information is provided either by the car’s electric power steering system, or by the steering angle sensor, which is part of the car's ESP anti-skid system. Bosch says that the feature can therefore be installed cost-effectively and helps further increase road safety.

The influence of fatigue on accidents has been demonstrated in a number of studies. In 2010, the 1765 American Automobile Association (AAA) published an analysis based on the accident data collected by the 834 National Highway Traffic Safety Administration (NHTSA) in the United States. The assessment showed that overtired drivers were at the wheel in 17 per cent of all fatal accidents in the US.

Fading concentration and fatigue compromise the driver’s steering behaviour and response time. Fine motor skills deteriorate, and steering behaviour becomes less precise. The driver corrects small steering mistakes more often. The new driver drowsiness detection function is based on an algorithm which begins recording the driver’s steering behaviour the moment the trip begins. It then recognises changes over the course of long trips, and thus also the driver's level of fatigue. Typical signs of waning concentration are phases during which the driver is barely steering, combined with slight, yet quick and abrupt steering movements to keep the car on track. Based on the frequency of these movements and other parameters, among them the length of a trip, use of turn signals, and the time of day, the function calculates the driver's level of fatigue. If that level exceeds a certain value, an icon such as a coffee cup flashes on the instrument panel to warn drivers that they need a rest. The Bosch Driver Drowsiness
Detection function addresses an important aspect of the driver's condition, and can thus contribute to improving road safety.

Related Content

  • Telematics data aids hit and run driver conviction
    October 21, 2015
    Evidence provided by a telematics device has resulted in a suspended prison sentence for a motorist who ploughed into a pedestrian walking home from a Christmas celebration on 12 December last year, says anti-motor fraud unit, APU. The driver admitted the incident, as well as perverting the course of justice after he failed to stop after the incident and later denied responsibility. Other charges included failing to report an accident.
    Read More
  • Cost Benefit: a roundabout way of lighting
    October 20, 2022
    One of Europe’s first smart lighting systems specifically for roundabouts is operating in Hungary and making big energy savings for local government, explains Miklós Muranyi of NIF
    Read More
  • Cost Benefit: Utah traffic light scheme pays dividends
    March 15, 2019
    A traffic signal control scheme in Utah is being taken up by other US authorities. David Crawford finds out how the Beehive State is leading the way in DoT and driver savings Growing numbers of US state departments of transportation (DoTs) and their road users are gaining real financial benefits from an advanced approach to traffic signal monitoring recently developed in Utah. Central to the system is its use of automated traffic signal performance measures (ATSPM) technology, brought in to improve th
    Read More
  • WiM avoids bumps in the road
    May 5, 2020
    Road surfaces are deteriorating as years of budget squeezes bite among local authorities. Adam Hill asks leading Weigh in Motion players what effect this might be having on the accuracy of their technology – and how authorities can be made to see that WiM is a helpful tool
    Read More

Highlighted Content