Completely new concept for inflating airbags

Autoliv has announced it has developed a completely new concept for inflating airbags that is more environmentally friendly and more cost efficient than traditional inflator technologies. In addition, it reduces the inflator’s weight by 20 per cent compared to most inflators for the intended application.
March 22, 2012 Read time: 2 mins
4171 Autoliv has announced it has developed a completely new concept for inflating airbags that is more environmentally friendly and more cost efficient than traditional inflator technologies. In addition, it reduces the inflator’s weight by 20 per cent compared to most inflators for the intended application.

The new inflator went into production earlier this year, in a passenger-side airbag for a European manufacturer of premium-brand vehicles. It uses hydrogen and oxygen with inert gas to inflate the airbag, instead of pyro­technic substances. As a result, there are no waste particles at all from the combustion and no effluent gases, not even carbon dioxide. The only side product is regular vapour which, when cooled off, becomes just a few drops of pure water, making the inflator extremely environmentally friendly.

In addition, the mixing of the hydrogen and the oxygen takes place in the textile cushion of the airbag, instead of in a steel vessel as in traditional airbag inflators, which allows for a thinner and lighter steel container and reduces weight and costs.

Autoliv says the weight reduction depends on the original inflator but is approximately 20% compared to most traditional inflators for airbags on the front passenger side. If only a quarter of company’s own needs for such passenger airbag inflators were converted to the new hydrogen/oxygen technology, Autoliv says it would save 1,000 tons of steel every year. Additionally, the vehicles with the new inflator would reduce their fuel consumption by more than eight million litres over the expected life time of the vehicles.

The new APG hydrogen/oxygen inflator will primarily be used in frontal airbags for the front-passenger side where higher gas quantities are required than for other airbags in a vehicle. The next step for this technology is to develop a dual-stage version of the inflator to be able to adjust the gas flow to the severity of the crash and to other parameters. Autoliv says this will be done using two independent ignitors and varying the time lapse a few milliseconds between the ignitions.

For more information on companies in this article

Related Content

  • Tolling systems - interoperability is key
    January 25, 2012
    Is US tolling as fragmented and divided as some would have you believe? And are the technology suppliers so very entrenched? ITS International spoke to the market's leading suppliers. A few years back, the prevalent view was that the North American tolling market was characterised by fragmented, proprietary solutions, each existing in splendid isolation. The reality is that a combination of pragmatism and good old market forces have seen some concerted moves made towards interoperability in many areas.
    Read More
  • London debuts three more low-emission bus zones
    April 26, 2019
    Transport for London (TfL) and the city’s mayor Sadiq Khan have introduced three more low-emission bus zones (LEBZ) to help reduce toxic air in the UK capital. There are now 10 LEBZs in London, which are expected to reduce nitrogen oxide (NOx) by 90% along some of the capital’s most polluted roads. Buses operating within the zones meet the cleanest emissions standards and have been delivered through a combination of new and retrofitted vehicles, TfL says. The three new zones in Lewisham, Stratford and
    Read More
  • Optibus gets its message across
    October 25, 2024
    Passenger Billboards convert complex service data into information displays
    Read More
  • Traffic management to the fore at Vision 2014
    December 8, 2014
    Colin Sowman reviews some of the traffic-related exhibits at the 2014 Vision Show in Stuttgart. Traffic was a major theme at this years’ Vision Show in Stuttgart and several manufacturers used the exhibition to highlight their traffic-related equipment and applications.
    Read More

Highlighted Content