Clutchless multi-speed transmission for EVs

Transmission specialist Zeroshift has devised a multi-speed gearbox for electric vehicles (EVs) that needs no clutch.
February 1, 2012 Read time: 1 min
Zeroshift's multi-speed transmission concept changes gear without interrupting the torque, allowing EVs to run for longer at peak efficiency.

Transmission specialist 1994 Zeroshift has devised a multi-speed gearbox for electric vehicles (EVs) that needs no clutch. A damper inside the gear hubs and electronic control of the motor make ratio changes seamless. The company claims the innovation could enable manufacturers to downsize EVs’ electric motors, keeping them running longer at the medium loads and speeds where peak efficiency of over 95 per cent is possible. For drivers, that could mean more performance, greater range and longer lasting batteries.

Zeroshift’s managing director Bill Martin says: “Our studies suggest that by using a compact, multi-speed transmission and a smaller electric motor, manufacturers can gain an operating efficiency of up to 10 per cent. You can use that 10 per cent to improve EVs’ range or reduce the size, weight and cost of battery packs.”

Zeroshift’s concept prevents any torque interruptions during ratio changes and does not require a clutch, issues that have so far deterred EV manufacturers from fitting multi-speed gearboxes. Current EVs instead use a single-speed transmission, but the motor then spends more of its time outside of its optimum efficiency range.

Related Content

  • In-vehicle automation of safety compliance and other traffic violations
    January 24, 2012
    David Crawford explores new initiatives in enforcement. Achieving the EU’s new road safety target of reducing road traffic deaths by 50 per cent by 2020 depends on removing legal and institutional barriers to the deployment of new enforcement technologies, stresses Jan Malenstein. The senior ITS Adviser to Dutch National Police Agency the KLPD, and a European-level spokesperson on road and traffic safety, points to the importance of, among other requirements, an effective EUwide type approval process for fr
    Read More
  • ITS industry needs more effort to get to the future
    January 19, 2012
    Eric Sampson, visiting professor at Newcastle University and City University London and ambassador for ITS-UK, provides a retrospective on the last couple of decades and takes a look at what the ITS industry still needs to do to get to where it needs to be
    Read More
  • Dutch survey shows drivers are in favour of road user charging
    January 16, 2012
    'Keep it simple, stupid' is an oft-forgotten axiom but in terms of road user charging it is entirely appropriate. So says the ANWB's Ferry Smith. A couple of decades ago, it might have been largely true that the technology aspects of advanced road infrastructure were the main obstacles to deployment. However, 20 years or more of development have led to a situation where such 'obstacles' are often no more than a political fig-leaf. Area-wide Road User Charging (RUC) is a case in point; speak candidly to syst
    Read More
  • Emissions reductions targets to have major impact on transport
    October 28, 2015
    As bold moves aimed at reducing greenhouse gas emissions have been introduced in California, David Crawford looks at the ramifications for transportation. California Governor Jerry Brown’s recent dramatic raising of the bar on emissions reduction policy for the state has won him praise from Japan, Australia, Europe and the secretariat of the critical UN conference on climate change being held in Paris in November/December 2015. His April 2015 executive order aimed at bringing emissions to 40% below 1990 lev
    Read More

Highlighted Content