Skip to main content

The challenges of start-stop technology

According to automotive technology supplier Dayco, the number of vehicles featuring start-stop technology will continue to rise over the next few years. The company says that it is only by incorporating such a function into a number of models in each range, that vehicle manufacturers will be able to reduce their fleet average emission levels and achieve the targets that EU legislation demands. Dayco, in alliance with Peugeot/Citroën, has developed a starter/alternator that has an auxiliary belt system w
September 9, 2013 Read time: 2 mins
According to automotive technology supplier Dayco, the number of vehicles featuring start-stop technology will continue to rise over the next few years.  The company says that it is only by incorporating such a function into a number of models in each range, that vehicle manufacturers will be able to reduce their fleet average emission levels and achieve the targets that EU legislation demands.

Dayco, in alliance with Peugeot/Citroën, has developed a starter/alternator that has an auxiliary belt system with the strength to start and restart the engine instantly when the vehicle needs to pull away, but is no wider than a standard auxiliary belt. In contrast to a conventional belt system, the patented Dayco self tensioning system (STS) maintains a balanced tension on both sides of the belt in relation to the starter/alternator drive pulley. Instead of having a tensioner on just one side of the belt system, the tensioning device connects both sides of the starter/alternator belt system.

The Dayco STS is designed to create a balance of forces between the two sides at all times, which enables the starter/alternator to seamlessly switch between its starting and charging modes to allow the vehicle’s start-stop system to function to its full potential.

The major development of this self-balancing device is the rigid connection of its pulleys, which allows it to maintain the correct belt tension irrespective of the direction of the load.

Related Content

  • Kapsch ‘opens the way’ to interoperability
    July 30, 2013
    Richard Turnock, chief technology officer of Kapsch TrafficCom North America explains what advantages its newly-opened TDM protocol can offer as a US-wide standard for tolling interoperability. The electronic tolling industry across the United States is evolving. Historically it was characterised by clusters of interoperability where a motorist may be able to use the same transponder across a large area, such as the 15-State E-ZPass system, or be confined to a single State system. Now, however, the industry
  • IP technology the route to efficient multi-agency control rooms
    February 1, 2012
    As IP-based technology makes its presence felt in the control room sector, it makes for greater economies of scale and also offers a migration path for many other traffic management technologies. So says Barco's Guy Van Wijmeersch. Efficient control room collaboration and decision-making is only possible if operators and decision-makers have easy and timely access to information. In many cases, that information also needs to be accessible to multiple users at the same time. This is certainly so in the case
  • European trends in environmental monitoring and enforcement
    February 2, 2012
    David Crawford surveys European trends in environmental monitoring and enforcement
  • More than half of UK’s new cars sold with autonomous safety tech
    April 4, 2016
    Self driving cars may seem years away, but more than 1.5 million UK motorists a year now leave showrooms in cars featuring self-activating safety systems, according to analysis revealed by the Society of Motor Manufacturers and Traders (SMMT).

    Data from SMMT and JATO Dynamics shows that more than half of new cars registered in 2015 were fitted with safety-enhancing collision warning systems, with other technologies such as adaptive cruise control, autonomous emergency braking and blind spot monitoring also surging in popularity.