Skip to main content

California aims to generate electric power from traffic congestion

California is planning a US$2.3 million initiative that will generate electrical power from traffic, according to the San Francisco Chronicle. The California Energy Commission recently voted to fund two piezoelectricity projects, which convert pressure into power. One pilot will test a 200-foot-long piece of asphalt on UC-Merced’s campus, which is designing a 200-foot stretch of asphalt that will be sowed with inch-wide piezoelectric generators, which will be stacked within arrays below the road where it is
April 20, 2017 Read time: 2 mins
California is planning a US$2.3 million initiative that will generate electrical power from traffic, according to the San Francisco Chronicle. The 4259 California Energy Commission recently voted to fund two piezoelectricity projects, which convert pressure into power.


One pilot will test a 200-foot-long piece of asphalt on UC-Merced’s campus, which is designing a 200-foot stretch of asphalt that will be sowed with inch-wide piezoelectric generators, which will be stacked within arrays below the road where it is hoped they will convert the force of passing cars into a small electrical charge.

The resulting electricity could be used to power nearby lights and signs, stored in batteries or sent to the grid, Sun said. The more traffic there is, and the heavier the vehicles are, the more power can be created. Some state estimates suggest that just 400 cars an hour would need to pass over the arrays to make them economically viable.

The second experiment will be built by the San Jose green technology company Pyro-E. The company's technology is expected to generate enough power to supply 5,000 homes using less than a half-mile of piezoelectric highway.

Both pilot programs are expected, within two to three years, to be able to give California officials an idea whether the effort should be expanded. By developing new technologies like piezoelectricity, the Energy Commission is looking to help meet the Legislature’s target of producing 50 per cent of the state’s power from renewable sources by 2030.

For more information on companies in this article

Related Content

  • High-resolution, compact telephotos for ITS from Theia
    May 31, 2024
    All Theia’s lenses are able to identify plates at a variety of speeds and distances
  • Berlin introduces wirelessly-charged electric bus Line
    September 4, 2015
    Berlin has become the first capital city to introduce a wirelessly charged electric bus, as part of a project funded by Federal Ministry of Transport and Digital Infrastructure. The Berlin Transport Authority, Berliner Verkehrsbetriebe (BVG) has introduced four Solaris Urbino 12 electric buses equipped with the Bombardier Primove inductive charging system and traction equipment from Vossloh Kiepe. The buses now operate on the 6.1 kilometre line 204 between Südkreuz and Zoologischer Garten (Hertzallee). Vos
  • Mounting benefits of dynamic tolling project
    January 30, 2012
    Wisconsin's four-year HOT lanes pilot project, launched in May 2008, cost US$18.8 million to construct. Halfway into the project, which uses variably priced, or dynamic, tolling to improve highway efficiency, the benefits are mounting. The problem was obvious, and frustrating, to anyone who ever sat in bumper-to-bumper traffic on State Route 167 and watched a lone car whiz by every 20 seconds or so in the carpool lane. But for planners at the Washington State Department of Transportation, the conundrum was
  • Measuring vehicle lengths with a single loop - promising results
    July 27, 2012
    District 7 of Caltrans has been conducting trials to see whether the use of a single inductive loop to measure vehicle lengths and so identify heavy trucks is feasible. So far, the results have been very promising, according to Lead Transportation Engineer Steve Malkson. Between them, the adjoining ports of Los Angeles and Long Beach, the US's two biggest, cover some 10,700 acres (43km2) and 68 miles (109km) of waterfront.