Skip to main content

California aims to generate electric power from traffic congestion

California is planning a US$2.3 million initiative that will generate electrical power from traffic, according to the San Francisco Chronicle. The California Energy Commission recently voted to fund two piezoelectricity projects, which convert pressure into power. One pilot will test a 200-foot-long piece of asphalt on UC-Merced’s campus, which is designing a 200-foot stretch of asphalt that will be sowed with inch-wide piezoelectric generators, which will be stacked within arrays below the road where it is
April 20, 2017 Read time: 2 mins
California is planning a US$2.3 million initiative that will generate electrical power from traffic, according to the San Francisco Chronicle. The 4259 California Energy Commission recently voted to fund two piezoelectricity projects, which convert pressure into power.


One pilot will test a 200-foot-long piece of asphalt on UC-Merced’s campus, which is designing a 200-foot stretch of asphalt that will be sowed with inch-wide piezoelectric generators, which will be stacked within arrays below the road where it is hoped they will convert the force of passing cars into a small electrical charge.

The resulting electricity could be used to power nearby lights and signs, stored in batteries or sent to the grid, Sun said. The more traffic there is, and the heavier the vehicles are, the more power can be created. Some state estimates suggest that just 400 cars an hour would need to pass over the arrays to make them economically viable.

The second experiment will be built by the San Jose green technology company Pyro-E. The company's technology is expected to generate enough power to supply 5,000 homes using less than a half-mile of piezoelectric highway.

Both pilot programs are expected, within two to three years, to be able to give California officials an idea whether the effort should be expanded. By developing new technologies like piezoelectricity, the Energy Commission is looking to help meet the Legislature’s target of producing 50 per cent of the state’s power from renewable sources by 2030.

For more information on companies in this article

Related Content

  • Dual purpose for new weigh-in-motion site
    October 13, 2014
    A new weigh-in-motion weighbridge is being installed on State Highway 1 at the Rakaia Bridge to support the introduction of high productivity motor vehicles (HPMV) on this key South Island, New Zealand, freight route. The HPMV system allows vehicles carrying a divisible load of essential goods to weigh more than the official 44 metric tonnes without a permit, but only on specified routes.
  • New connected vehicle data sets available in the Research Data Exchange (RDE)
    May 4, 2016
    New connected vehicle data environments are now available in the US. Department of Transportation's Research Data Exchange (RDE). This web-based data resource collects, manages, and provides access to archived and real-time multi-source and multi-modal data to support the development and testing of intelligent transportation system applications. The RDE now houses the following three additional data environments:
  • Measuring alertness to avert drowsy driver incidents
    December 21, 2015
    Falling asleep at the wheel is the primary cause in thousands of deaths on American and other roads, with truck drivers the most at-risk group. David Crawford investigates measures to counter drowsy driving.
  • PwC surveys EV market potential
    April 19, 2012
    Collaboration between industry participants will be essential to bring alternative fuel applications to market, according to PwC's latest publication Charging Forward: Electric Vehicle Survey. While automakers continue to bring electric vehicles (EVs) to the marketplace, governments, local municipalities and utility companies are challenged with building the infrastructure required to support these vehicles long before mainstream consumption will take hold. PwC surveyed over 200 executives across multipl