Skip to main content

Australian highway upgrade gets under way

Work has begun on a US$130.8 million major upgrade to the Bruce Highway to increase the route’s capacity in north Queensland. The upgrade will increase seven kilometres of highway from two lanes to four lanes, with major works to be carried out on the intersections at Hunter Street, Abbott Street, Lakeside Drive and Stuart Drive. Federal MP George Christensen says a four lane overpass of the rail line at Cluden will be built to separate traffic from the existing open level crossing to improve safety on
October 31, 2013 Read time: 1 min
Work has begun on a US$130.8 million major upgrade to the Bruce Highway to increase the route’s capacity in north Queensland.  The upgrade will increase seven kilometres of highway from two lanes to four lanes, with major works to be carried out on the intersections at Hunter Street, Abbott Street, Lakeside Drive and Stuart Drive.

Federal MP George Christensen says a four lane overpass of the rail line at Cluden will be built to separate traffic from the existing open level crossing to improve safety on the highway.

“The project will also construct two new bridges over Stuart Creek, as well as new drainage structures under other sections to improve flood immunity and reduce the number of highway closures because of flooding,” he says.

All works are due to be completed by mid-2015.

Related Content

  • Fluor consortium named preferred bidder for Netherlands motorway project
    July 1, 2016
    Dutch engineering company Fluor Corporation is part of the 3Angle consortium, a special purpose company selected as the preferred bidder by the Directorate-General for Public Works and Water Management of the Netherlands (Rijkswaterstaat) for the A27/A1 public private partnership (PPP) project in the Netherlands. The 3Angle consortium, comprised of Fluor, Heijmans Capital and 3i Infrastructure, will carry out the design, build, management, maintenance and financing of existing and new infrastructure of t
  • Dual purpose for new weigh-in-motion site
    October 13, 2014
    A new weigh-in-motion weighbridge is being installed on State Highway 1 at the Rakaia Bridge to support the introduction of high productivity motor vehicles (HPMV) on this key South Island, New Zealand, freight route. The HPMV system allows vehicles carrying a divisible load of essential goods to weigh more than the official 44 metric tonnes without a permit, but only on specified routes.
  • APT SkiData equips Gatwick Airport parking development
    March 23, 2012
    APT SkiData has completed the installation of equipment that will manage and control parking for over 1,000 additional vehicles at London’s Gatwick Airport following the construction of a new short stay car park at its North Terminal.
  • Intersection collision avoidance system trial
    January 31, 2012
    Although much of the emphasis of research into intersection management has tended to concentrate on the needs of urban locations, there remain specific issues pertaining to rural intersections which need to be addressed. Here, Rebecca Szymkowski and Greg Helgeson, Wisconsin DOT, Todd Szymkowski, University of Wisconsin-Madison, and Craig Shankwitz and Arvind Menon, University of Minnesota detail progress on an intersection collision avoidance system for more remote locations.