2getthere’s Group Rapid Transit vehicle passes desert climate test

2getthere’s Group Rapid Tansit (GRT) autonomous vehicle has proven in a simulated desert climate that it can maintain an indoor temperature of 23˚C even in the worst scenario (52˚C outside temperature and 3% humidity). The climate test took place in the Utrecht province and is one of many tests regarding the mega-order received from United Arab Emirates earlier this year. From 2020, five vehicles will perform fully autonomous shuttle services to and from Bluewater Island in Dubai.
October 26, 2017 Read time: 2 mins

8172 2getthere’s Group Rapid Tansit (GRT) autonomous vehicle has proven in a simulated desert climate that it can maintain an indoor temperature of 23˚C even in the worst scenario (52˚C outside temperature and 3% humidity). The climate test took place in the Utrecht province and is one of many tests regarding the mega-order received from United Arab Emirates earlier this year. From 2020, five vehicles will perform fully autonomous shuttle services to and from Bluewater Island in Dubai.

GRT was subject to three tests in weather conditions such as ‘hot dry’ and ‘hot humid’ with a focus on the performance of the air conditioning system (ACS) at the vehicles maximum capacity of 24 passengers.

13 ACS has been developed in collaboration with suppliers DC Airco and Netherlands Aerospace Centre (NLR) who used the simulation of heat management in relation to airflow within the vehicle in its design of the air conditioning. Its development has been partly financed through a 2024 Massachusetts Institute of Technology research grant in which DC Airco and 2getthere have both participated.

The simulated weather conditions included extremely high temperatures and sun radiation with average peaks in the sun radiation of 1,040 Watts per square metre and peaks in temperature of 52˚C around 3.30pm. In the climatic chamber, both peaks were simulated at the same time.

The GRT’s 16 standing passengers represented 120 Watts each and eight seated passengers each represented 100 Watts were simulated by placing a 3000-Watt heat source inside the vehicle. Part of the test focused on performance during transition: the speed at which indoor conditions are brought back to the most comfortable level for passengers after the doors close and the vehicle starts its journey. The most extreme test was based on the vehicle standing still with the doors open for six minutes, but in actual circumstances much shorter stops will be sufficient to allow 24 passengers to enter the vehicle and find their seats.

According to 2getthere the test marks another step towards the operational deployment of the system, scheduled for 2019/2020.

For more information on companies in this article

Related Content

  • The rise and rise of robo-car
    July 23, 2019
    When it comes to driverless cars, there are many variables – but one thing is for certain: autonomous driving will have a significant impact on vehicle design, says Andreas Herrmann The transition to autonomous vehicles (AVs) means that many of the factors which have shaped automotive design for the past 130 years no longer apply. At present, the design of a car is largely determined by the anticipated direction of travel: the car’s silhouette immediately shows where the front and back are. Driverless ve
    Read More
  • Drive C2X ‘proves Europe is ready for cooperative systems roll-out’
    July 16, 2014
    The DRIVE C2X provides a comprehensive, Europe-wide assessment of cooperative systems through field operational tests, and is to present its results on 16 and 17 July in Berlin. The test results are the last step in the preparation for the roll-out of cooperative systems in Europe. During the three and a half years of the project, more than 750 drivers tested eight safety-related functions of cooperative functions all over Europe. The operational tests took place in seven test sites in Finland, France, G
    Read More
  • J-J Hooks barrier system passes demanding crash tests
    June 19, 2012
    Easi-Set Worldwide has announced that its J-J Hooks barrier system has successfully passed both bolted-down and pinned-down MASH Test Level 3 crash tests (MASH - Manual for Assessing Safety Hardware), out-performing other comparable systems. The tests were performed by the Texas Transportation Institute.
    Read More
  • Research shows smart charging can be key solution to challenge of network demand from EVs
    September 5, 2017
    The UK Electric Nation project is due to announce its initial findings on the first day of the Cenex Low Carbon Vehicle event (LCV2017) this week, which will show that smart charging can provide a key solution to the challenge of the demand from increasing numbers of electric vehicles (EVs) on electricity networks.
    Read More

Highlighted Content