Millbrook named as approved RDE testing facility for VCA

Millbrook Group, the independent vehicle testing and validation services provider, has been appointed as an approved facility to provide real driving emissions (RDE) testing by the UK’s Vehicle Certification Agency, VCA.
June 22, 2017 Read time: 1 min

Millbrook Group, the independent vehicle testing and validation services provider, has been appointed as an approved facility to provide real driving emissions (RDE) testing by the UK’s Vehicle Certification Agency, VCA.

The announcement comes after Millbrook was also designated to provide similar services to Dutch authority, RDW, and follows significant investment in Millbrook’s Powertrain department to develop its emissions-testing capabilities. Investment has enhanced Millbrook’s RDE data capture, through the latest portable emissions measurement systems (PEMS) and software.

Millbrook’s approval from the VCA covers testing procedures 2016/646 and 595/2009 on light and heavy duty vehicles respectively. The facilities at the Bedfordshire site are able to cover current, and immediately expected, EU regulations for real driving emissions. VCA has a permanent presence at Millbrook, making the conducting of official, regulated procedures more efficient and saving vehicle manufacturers’ time when putting their vehicles through official tests.

Air Quality & Weather Systems

Related Content

  • September 30, 2016
    Extended UKAS accreditation for Millbrook’s safety testing
    UK independent vehicle test, validation and engineering services provider Millbrook Group has been awarded an extension certificate for seat belt anchorage and pedestrian impact tests by the UK Accreditation Service (UKAS). This is in addition to the recent commissioning of the roll over and small offset testing facility for full scale crashes. Millbrook’s crash test and safety capabilities include: corkscrew roll over and small-offset testing (opened in Q3 2016); full scale vehicle crash testing to a wi
    Read More
  • February 15, 2017
    Automotive OEMs standardise testing to comply with RDE deadlines, say researchers
    Following 'dieselgate', the previously lax automobile emission testing procedures tightened and all European original equipment manufacturers (OEMs) are now required to implement real driving emissions (RDE). In September, RDE testing will have a conformity factor of 2.1, which will change to 1.5 by September 2021. OEMs will be more transparent with their testing methods and results. After the implementation of RDE, adoption of World Harmonisation Light Vehicle Test Procedure (WLTP) will be simpler. The
    Read More
  • December 12, 2016
    Millbrook Group opens new 4WD emissions test facility
    Independent vehicle test, validation and engineering service provider Millbrook Group has opened its new, state-of-the-art four-wheel drive (4WD) climatic emissions chassis dynamometer. The facility operates at temperatures between minus 20 and plus 50 degrees centigrade and is used to measure vehicle emissions, CO2, fuel consumption, electric consumption and range and climatic performance of passenger cars and light commercial vehicles under repeatable conditions. It boasts a high performance fully t
    Read More
  • November 18, 2015
    Real-world testing is needed in wake of VW emissions scandal, says expert
    As vehicle manufacturers, regulators and governments around the world seek solutions to prevent another emissions cheating scandal similar to the Volkswagen case, a major vehicle emissions inspection company has compiled and analysed on-road emissions data indicating that emissions violations of vehicles under real-world driving conditions may well go far beyond VW diesels. Opus Inspection says a two-pronged approach that continuously monitors real-world emissions is the only effective remedy. Lothar Ge
    Read More

Highlighted Content