MVIS VMS solution deployed on Highways England’s road upgrade project

Mobile Visual Information Systems (MVIS) has implemented its DATEX journey time solution (JTS) on Highway’s England’s US$1.9 billion (£1.5billion) A14 Cambridge to Huntingdon upgrade scheme, enabling an average of 85,000 drivers daily who use the 21 mile stretch of road to navigate the roadworks. The project incorporates 26 Bartco UK VMS-Cs variable message signs which display journey times from their locations to the end of the affected stretch of road
September 4, 2017 Read time: 1 min

6918 Mobile Visual Information Systems (MVIS) has implemented its DATEX journey time solution (JTS) on Highway’s England’s US$1.9 billion (£1.5billion) A14 Cambridge to Huntingdon upgrade scheme, enabling an average of 85,000 drivers daily who use the 21 mile stretch of road to navigate the roadworks. The project incorporates 26 8321 Bartco UK VMS-Cs variable message signs which display journey times from their locations to the end of the affected stretch of road, informing drivers of the predicted journey duration and if possible, enabling them to select alternative routes.

The journey times shown are calculated using DATEX II actual time journey time data collected from in-vehicle sensors and relayed by the National Traffic Operations Centre (NTOC).  These times are renewed every five minutes.  The messages displayed replicate those shown on 8101 Highways England’s fixed signs.

Air Quality & Weather Systems Urban Traffic Control

For more information on companies in this article

Related Content

  • TM 2.0 boost TMC data feed and driver influence
    November 15, 2017
    TM 2.0 views connected vehicles and V2I as two-way communications channels, benefitting traffic management and drivers, as Alan Dron discovers. As connected vehicles are progressively rolled out there will come a point at which traffic managers and traffic management centres (TMCs) will have to gear up to cope with a rapidly-evolving road scenario. The TM 2.0 Platform (see box) is promoting a concept of new-generation traffic management (which carries the same TM 2.0 title) and is studying how future T
    Read More
  • DriveWyze wireless Preclear system speeds weighstation waiting
    March 1, 2013
    Drivewyze aims to revolutionise the way weighstation bypass systems work with its Pre-Clear system. And it’s not just looking at weighstations, either… Pete Goldin reports. Truck drivers know the drill: pull off the high­way at every weighstation and wait. Carriers know the drill, too: every minute spent waiting there translates directly into dollars lost. Traditionally, the only alternative to this scenario is a transponder-based system, which allows trucks to bypass the sites using technology similar to
    Read More
  • Vehicle to improve safety and reduce disruption on motorways
    May 26, 2016
    Inspired by the aviation industry, a new vehicle developed by Highways England to help replace overhead signs is set to reduce the duration of roadworks. The vehicle is based on the design of an aircraft catering vehicle, which loads refreshments into aeroplanes using a hydraulic scissor lift. Traditionally, signs are taken down and installed using a flat-bed truck, crane and cherry picker, taking up to 40 minutes. However the new Maintenance Assistance Vehicle (MAV) can do this in around 20 to 25 min
    Read More
  • Cost Benefit: the economic case for cycling
    August 20, 2019
    Cycling is good for us for any number of reasons. David Crawford finds that it is now possible to access basic, low-cost data which will help make the economic case for improving infrastructure Cycling is enjoying a favourable press the world over as a ‘good thing’ in the economic, environmental and social spheres. A recent study on the Value of Cycling from the UK’s University of Birmingham, for example, shows that cycle-friendly urban settings can deliver annualised transport infrastructural support co
    Read More

Highlighted Content