UK’s M3 gets smart

Work begins shortly on the initial phase of a US$278 million project to improve the M3 between the M25 and Farnborough. The section between junctions 2 and 4a will become a smart motorway, adding a fourth lane in both directions in place of the hard shoulder and adding enhanced on-road technology to keep traffic moving safely and reliably, providing a boost for businesses and the wider economy. The road will also be resurfaced with a new, low noise material. The main works are due to be completed by the
October 30, 2014 Read time: 1 min
Work begins shortly on the initial phase of a US$278 million project to improve the M3 between the M25 and Farnborough.

The section between junctions 2 and 4a will become a smart motorway, adding a fourth lane in both directions in place of the hard shoulder and adding enhanced on-road technology to keep traffic moving safely and reliably, providing a boost for businesses and the wider economy. The road will also be resurfaced with a new, low noise material. The main works are due to be completed by the end of 2016.

503 Highways Agency project manager Pranav Devale said: This busy section of the M3 is used for more than 130,000 journeys every day, and these vital improvements will add much needed extra capacity. Smart motorways are a safe, cost effective solution for improving journeys.”
Air Quality & Weather Systems Urban Traffic Control Enforcement

For more information on companies in this article

Related Content

  • Newcastle rush-hour traffic trials get the go-ahead
    February 15, 2013
    Traffic trials aimed at streamlining the rush-hour commute in the UK’s north-east have been given the green light. The project in Newcastle involves new satellite navigation technology which helps drivers adjust their speed so they can pass through a series of lights on green. The European project is being led by Newcastle University and Newcastle City Council, and aims to reduce city centre congestion and pollution associated with stop-start driving. Phil Blythe, Professor of Intelligent Transport Systems
    Read More
  • Two wheels good
    June 25, 2018
    As cycling becomes an increasingly popular method for commuting and recreation, what moves are afoot to keep the growing numbers of cyclists safe on ever-more-busy roads? Alan Dron puts on his helmet and pedals off to look. It would have seemed incredible just a decade ago, but cycling in London has become almost unfeasibly popular. The Transport for London (TfL) June 2017 Strategic Cycling Analysis document noted there were now 670,000 cycle trips a day in the UK capital, an increase of 130% since 2000.
    Read More
  • Tolling is the 21st century’s road funding solution
    June 5, 2015
    HNTB’s Rick Herrington and Brad Guilmino put the case for tolling. Tolling is becoming the 21st century solution of choice for generating additional user-based transportation revenue. The proven funding source is being seriously considered for expanded use by cities, states and even the federal government with support from elected officials across the political spectrum. In fact, with each federal transportation reauthorisation, tolling restrictions have been relaxed.
    Read More
  • New York’s Hudson Bridge goes AET
    October 15, 2014
    New York’s Metropolitan Transportation Authority Bridges & Tunnels (MTA B&T) has selected TransCore to deploy the agency’s first all-electronic tolling (AET) system on the historic Henry Hudson Bridge. Built in 1936, the iconic bridge provides passage for more than 63,000 vehicles each day. The AET project is part of a three-year, US$33 million MTA B&T bridge rehabilitation project to replace the original 1930s steel supports as well as install 3,600 feet of new bridge decking, new energy-efficient roadw
    Read More

Highlighted Content