Vehicle to improve safety and reduce disruption on motorways

A new maintenance assistance vehicle (MAV) developed by Highways England and Mott MacDonald to help replace overhead signs was inspired by an aircraft catering vehicle and is set to reduce the duration of roadworks.
September 16, 2016 Read time: 1 min

A new maintenance assistance vehicle (MAV) developed by 8101 Highways England and 1869 Mott MacDonald to help replace overhead signs was inspired by an aircraft catering vehicle and is set to reduce the duration of roadworks.

Traditionally, signs are mounted and removed using a flat-bed truck, crane and access platform – a process that can take up to 40 minutes. However with the MAV’s hydraulically elevating body, this can be achieved in around 20 to 25 minutes by using a small jib crane which is mounted on the vehicle itself.

Once elevated to the correct height, the jib crane lifts the detached sign off the gantry and the operatives use a trolley to move it into the truck’s main body. This procedure is reversed when installing a new signs.

The hydraulically powered scissor lift enables the signs at heights of up to 8.5m to be serviced in wind speeds of up to 47mph, while its CCTV cameras enable the driver to correctly position the vehicle below the gantry before maintenance and monitor the operatives while they work.

Urban Traffic Control

Related Content

  • ProPart AV trial crosses the line
    March 25, 2020
    The perceived safety benefits of autonomous vehicles can only be realised with precise positioning. Ben Spencer reports from Sweden on work by a European consortium which aims to use the technology to allow a truck to carry out an automated lane change
    Read More
  • Progressing work zone safety systems
    February 1, 2012
    David Crawford investigates progress in a key safety area - work zones. Highway construction zone safety is taken seriously enough in the US to merit a special spring National Work Zone Awareness Week, which in 2010 ran from 19-23 April. Headed by the US Department of Transportation's Federal Highway Administration (FHWA), this aims to reduce an annual toll of work zone deaths - 720 in 2008 (an average of one every 10 hours) with more than 40,000 traffic injuries (an average of one every 13 minutes).
    Read More
  • Progressing work zone safety systems
    February 6, 2012
    David Crawford investigates progress in a key safety area - work zones
    Read More
  • Bluetooth and Wi-Fi offer new options for travel time measurements
    November 20, 2013
    New trials show Bluetooth and Wi-Fi signals can be reliably used for measuring travel times and at a lower cost than an ANPR system, but which is the better proposition depends on many factors. Measuring travel times has traditionally relied automatic number plate (or licence plate) recognition (ANPR/ALPR) cameras capturing the progress of vehicles travelling along a pre-defined route. Such systems also have the benefit of being able to count passing traffic and have become a vital tool in dealing with c
    Read More

Highlighted Content