Rediweld slims down cycle lane separators

Rediweld has introduced a new narrower version of its surface-mounted Orca cycle lane separator called the Orca Kerb which is only 150mm wide rather than 200mm as in the original unit. On the cycle side of the 100mm high Orca Kerb is a splayed face to guide a cycle tyre back into the lane rather than tripping the cyclists, while on the traffic side is a vertical half-battered face to deter vehicles crossing into the cycle lane. Also unlike the original, the recycled rubber Orca Kerb comes in lengths of up
June 16, 2015 Read time: 1 min

8153 Rediweld has introduced a new narrower version of its surface-mounted Orca cycle lane separator called the Orca Kerb which is only 150mm wide rather than 200mm as in the original unit.

On the cycle side of the 100mm high Orca Kerb is a splayed face to guide a cycle tyre back into the lane rather than tripping the cyclists, while on the traffic side is a vertical half-battered face to deter vehicles crossing into the cycle lane. Also unlike the original, the recycled rubber Orca Kerb comes in lengths of up to 1m allowing intermittent or continuous segregation of cycle lanes.

Urban Traffic Control

For more information on companies in this article

Related Content

  • Dynamic charging boosts electric vehicles’ potential
    December 16, 2014
    With an increasing need to use electric vehicles in city centres to reduce pollution, David Crawford looks at various solutions to power delivery. The UN’s September 2014 Climate Summit has added fresh momentum to the drive to increase urban electric vehicle (EV) takeup. It has launched the Urban Electric Mobility Initiative, which wants to see EVs accounting for 30% of all urban travel by 2030, and make cities worldwide more friendly to their use. Encouragingly, the plan is being well supported by commerci
    Read More
  • Making cycling safer in Bournemouth
    January 16, 2014
    Cyclists using a busy intersection in Bournemouth, UK, are benefiting from an in-road cycle detection solution installed at the traffic signals. The intersection joins a major route into the city centre and experiences high traffic flows throughout the day. A designated cycle lane was installed along with an advanced stop line and an M100BR bicycle detection system supplied by Clearview Traffic. The M100BR works in conjunction with the traffic signals to detect cyclists approaching the junction. When a
    Read More
  • Libelium’s surface-mounted sensor provides long-range solution
    April 5, 2016
    Visitors to Intertraffic are amongst the first to see the new surface-mounted version of Libelium’s Waspmote Plug&Sense smart parking device which senses if a parking bay is occupied. The new version can be installed in about five minutes which, according to the company, means six of the surface mounted units can be installed in the time it would take to install one of the traditional in-road units.
    Read More
  • Australia's ground breaking average speed enforcement
    February 1, 2012
    The speed enforcement system on the Hume Highway in Australia combines both spot and point-to-point solutions. Here, Redflex's Peter Whyte discusses its implementation. The Australian State of Victoria has achieved notable success in reducing casualty rates since launching a three-pronged road accident prevention initiative in the late-1980s.
    Read More

Highlighted Content