Skip to main content

UK city to introduce thermal imaging traffic management

City of York Council is to introduce thermal imaging technology on key cycle routes in York to help reduce the time spent at traffic signals, improve journey reliability and cycle safety. The city is set to become one of the first councils in the country to start using the technology which will accurately detect cyclists at signals by their ‘heat signature’, allowing the signals to react accordingly and be adjusted to give more ‘green time’ for cyclists. The thermal technology was first introduced by
March 24, 2016 Read time: 2 mins
City of York Council is to introduce thermal imaging technology on key cycle routes in York to help reduce the time spent at traffic signals, improve journey reliability and cycle safety.

The city is set to become one of the first councils in the country to start using the technology which will accurately detect cyclists at signals by their ‘heat signature’, allowing the signals to react accordingly and be adjusted to give more ‘green time’ for cyclists.

The thermal technology was first introduced by 1466 Transport for London last year as part of the cycle superhighway network.

The scheme is all part of a multi million pound overhaul of York’s ageing traffic signals – the largest scheme the city has seen since the last major overhaul of York’s traffic signals in the mid 1990s which introduced the city’s new urban traffic control system to control the city’s transport network.

The five year scheme also includes replacement of worn out and unreliable in-road road loops with camera systems for traffic detection.

The authority is also proposing to replace approximately half of the 122 traffic signals and 54 pedestrian crossings in the city over a five-year rolling programme with modern equipment.

For more information on companies in this article

Related Content

  • MTA's Bronx bus route re-jig 'streamlines' trips
    February 28, 2023
    New York's transit agency says commute times for bus riders have been cut
  • Vendor's eye view of US economic stimulus programme
    March 12, 2012
    Pete Goldin explores the impact of the US economic stimulus programme on the ITS industry from the ITS vendor perspective
  • Port authority to replace ITS system at George Washington bridge
    November 16, 2012
    The Intelligent Transportation System (ITS) at the George Washington Bridge (GWB), first installed in 1997, is to be replaced by the Port Authority of New York and New Jersey as part of a road improvements being planned throughout the region. The ITS provides information on traffic conditions, estimated travel times, and lane restrictions to motorists via electronic signs on roads leading to the GWB. An estimated 101 million vehicles crossed the world’s busiest crossing in both directions in 2011. Work on t
  • European tunnel safety steps up a gear
    September 19, 2017
    David Crawford reviews the latest safety systems installed in European tunnels. Blueprints for the safer road tunnels of the future are emerging fast as European operators invest in technologies to enhance travellers’ prospects of surviving an accident. Central to modern emergency planning is the principle that, following an incident, drivers should be enabled to rescue themselves and their passengers with the aid of prompt and correct identification and communication of the hazard. Roles for cooperativ