Skip to main content

NEMA publishes new standard for portable traffic signals

The US National Electrical Manufacturers Association (NEMA) has published NEMA TS 5-2017 Portable Traffic Signal Systems (PTSS) Standard.
May 22, 2017 Read time: 1 min

The US 7174 National Electrical Manufacturers Association (NEMA) has published NEMA TS 5-2017 Portable Traffic Signal Systems (PTSS) Standard. This new standard covers traffic signalling equipment used to enable and expedite the safe movement of vehicle traffic in work zones during roadway construction, such as single-lane road closures during emergencies and planned events.

PTSS are commonly used to supersede flag use during roadway construction. While PTSS are used most commonly for single-lane road closures, they are also used during or after times of emergencies, planned events and non-normative vehicular signalisation needs.

PTSS are also used before or while permanent signals are being installed to reduce traffic bottlenecks and improve intersection safety during these transition times. PTSS are designed to enable critical movement of traffic using the implementation of appropriate new and existing standards.

Related Content

  • May 2, 2012
    Cost-effective driver drowsiness detection
    Bosch has revealed that its driver drowsiness detection system, first introduced as a standard feature in 2010, in the new Volkswagen Passat is being fitted to the new Passat Alltrack. Fatigue and microsleep at the wheel are often the cause of serious accidents. However, the initial signs of fatigue can be detected before a critical situation arises, and the Bosch system can do this by monitoring steering movements and advising drivers to take a break in time. The required information is provided either by
  • September 6, 2017
    Remote remedies help US authorities identify bridge deficiencies
    Every day 185 million vehicles – cars, trucks, school buses, emergency response units - cross one or more of America’s 55,710 'structurally compromised' steel and concrete road bridges, the highest concentration of which are in Iowa (nearly 5,000), Pennsylvania and Oklahoma. Nearly 2,000 of these crossings are located on interstate highways, according to the American Road and Transportation Builders Association's recent analysis of the US Department of Transportation's 2016 National Bridge Inventory.
  • May 6, 2020
    Don’t forget security threat, says Econolite
    A new level of communication is helping deliver on the promise of Vision Zero and a more sustainable future. But amid the promise, Econolite’s Sunny Chakravarty suggests we need to be mindful of the potential downsides in an age of mass connectivity
  • August 6, 2013
    Monitoring, detection and control systems inside tunnels can do much to improve traveller safety
    ITS technology can do a great deal to improve tunnel safety, as Colin Sowman discovers. It was back in April 2004 that the European Parliament adopted the EU Directive which lays down the Minimum Safety Requirements for Tunnels in the Trans-European Road Network (2004/54/EC). This was the first unitary legislation setting minimum safety standards for European road tunnels and was designed to harmonise the management of tunnel safety at a national level. Operators of existing tunnels have until 30 April 201