Motorbike safety can be measured objectively, says AIT

The Austrian Institute of Technology (AIT) and TU Wien (Vienna University of Technology) has developed a motorcycle probe vehicle to better understand the causes of motorbike accidents. The vehicle was deployed as a measurement method to evaluate popular motorcycle routes in Austria’s capital. Peter Saleh, road safety expert at the AIT Center for Mobility Systems, says: “Our aim is to give those who operate roads the precise information they need in order to reduce the danger in these areas efficiently,
August 30, 2018 Read time: 2 mins
The 6625 Austrian Institute of Technology (AIT) and TU Wien (Vienna University of Technology) has developed a motorcycle probe vehicle to better understand the causes of motorbike accidents. The vehicle was deployed as a measurement method to evaluate popular motorcycle routes in Austria’s capital.


Peter Saleh, road safety expert at the AIT Center for Mobility Systems, says: “Our aim is to give those who operate roads the precise information they need in order to reduce the danger in these areas efficiently, sustainably and cost-effectively.”

The motorbike, a KTM 1290 Super Adventure, was equipped with high precision sensors and video systems. The side cases were packed with recording technology which documented the condition of the bike.

Test drives gathered data on vehicle dynamics, trajectory and routing. This was augmented with weather, traffic volume and route environment and then analysed through machine learning to reveal road sections which pose a risk for motorcyclists.

According to Saleh, every road section which was classed as dangerous - after being driven along and analysed - had been the site of serious accidents in the past.

“The AIT/TU Wien research team is therefore in a position to anticipate future accident trends and can assess motorcycle safety on a scientific basis, even before anything has happened,” Saleh adds.

Urban Traffic Control

For more information on companies in this article

Related Content

  • TomTom provides flexibility for Riyadh
    June 1, 2016
    With five years of traffic disruption ahead and an inadequate traffic monitoring system, the authorities in Riyadh needed a solution – and quickly. In preparation for embarking on what is currently the world’s largest metro construction project, the Arriyadh Development Authority (ADA) in Riyadh needed to put in place measures to minimise the additional congestion and travel delays the five-year project would inevitably cause.
    Read More
  • European tunnel upgrades following new safety legislation
    August 20, 2015
    Across Europe there is a very mixed picture of compliance to latest safety standards for road tunnels. Best practice has emerged, however, in the wake of European legislation. Jon Masters reports High profile fatal fires following accidents in the Mont Blanc, Tauern and Gotthard tunnels prompted the 2004 European Union Directive 2004/54 on road tunnel safety. This meant all EU member states would have to meet new standards of safety in road tunnels by 30 April 2014. The Directive applied to all tunnels over
    Read More
  • Sweden winning over doubters
    December 4, 2012
    Comparatively little negative comment has been made in Swedish media with regard to the country’s widespread speed enforcement, according to project manager Eva Lundberg of Trafikverket, Sweden’s Transport dministration. Lundberg is due to give a presentation at the Vienna World Congress special session on enforcement, probably with more than a passing word on public acceptance. Trafikverket has put a lot of work into its Vision Zero road safety strategy over the past few years; much of it targeting reducti
    Read More
  • Machine vision’s image of road management’s future
    June 11, 2015
    Q-Free’s Marco Sinnema looks at how the commoditisation of high-quality vision-based solutions is widening their application. Machine vision technology’s entry into the ITS/traffic management sector has followed a classic top-down path. This is unsurprising given the extremely demanding performance criteria which are the standard in its market of origin, manufacturing processing. Very high image qualities combined with frame rates often in the hundreds per second range resulted in vision systems with capabi
    Read More

Highlighted Content