Skip to main content

Michigan pilots pedestrian safety signs

New crosswalk signs have been installed in installed several southwest Michigan cities as part of a joint research project by the Michigan Department of Transportation (MDOT) and Western Michigan University (WMU). The project involves testing the crosswalk signs as potential low-cost safety measures to increase pedestrian safety and motorist awareness. The signs are designed to be permanently affixed to the road but can be removed for the winter when snow removal is necessary. The signs will be removed i
August 21, 2015 Read time: 2 mins
New crosswalk signs have been installed in installed several southwest Michigan cities as part of a joint research project by the 1688 Michigan Department of Transportation (MDOT) and Western Michigan University (WMU). The project involves testing the crosswalk signs as potential low-cost safety measures to increase pedestrian safety and motorist awareness.

The signs are designed to be permanently affixed to the road but can be removed for the winter when snow removal is necessary. The signs will be removed in mid-November this year and the research results are expected to be published early next year.

The signs have been installed at 10 crosswalks in three roundabouts and six intersections in five MDOT Southwest Region communities. Installation sites were chosen primarily to get a variety of intersection configurations such as full intersections, roundabouts, mid-block crosswalks, etc. Dr Ron Van Houten, the traffic safety research expert leading the WMU study said several factors were considered, such as lane width, the messages on signs and the types of signs used.

Van Houten said the study already is showing signs of increased pedestrian safety. "People are looking for pedestrians with the signs there," he said. "Our data shows drivers slow a bit, their heads are turning, and that is a good thing in an urban environment."

Carissa McQuiston, MDOT project manager and non-motorised safety engineer, said the study is designed to increase pedestrian crossing awareness for pedestrians and drivers. Signs have been placed at crosswalks in the road at the edge lines, centre lines and lane lines.

"We have very good preliminary data that supports this installation as a way to inform drivers of pedestrian presence and highlight their crossing activity," McQuiston said. "With these installations, the researchers are collecting data about pedestrian safety, drivers yielding, and the durability of the signs."

Van Houten said while the signs are designed to withstand some abuse from traffic, there has to be a balance of durability and cost. "Ideally, they will last a long time," he said. "It will cost the department more money if they have to replace them frequently."

Related Content

  • May 23, 2017
    Michigan Department of Transportation partners with 3M on connected work zone
    The Michigan Department of Transportation (MDOT) is partnering with 3M to utilise connected vehicle technologies along more than three miles of I-75. Using solutions from 3M, the current I-75 work zone in Oakland County will be transformed over the course of four months to improve safety for drivers and to test advanced vehicle to infrastructure technologies on the connected and autonomous vehicles of the future.
  • January 4, 2013
    Road signs removed to reduce ‘clutter’
    In a response to a move to remove unnecessary clutter in cities and rural areas, more than 9,000 road traffic signs have been taken down in England, where local councils have been urged to think more creatively about the number and location of their location. Ministers have warned that excessive signs can be a distraction to motorists and make roads appear unattractive. In October 2011, the requirement for certain road signs was lifted; the government plans to give councils more discretion over where they p
  • November 13, 2024
    ITS Australia Awards 2025 finalists announced

    ITS Australia has announced 32 finalists for the 15th Annual ITS Australia Awards, with winners announced at a ceremony on 13 February 2025 in Perth, Western Australia.

  • July 17, 2012
    ITS technology reduces congestion, improves workzone safety
    As the road-building season gets under way in the US, the Federal Highway Administration has just published a White Paper which deals with the use of ITS technology in work zones. On 30 April 2009, the US Federal Highway Administration (FHWA) published a White Paper which was prepared by the US Department of Transportation (USDOT) to inform public agencies about the use of ITS to manage construction work zones. This is a particularly relevant topic given the large number of construction projects that are ex