Skip to main content

Michigan pilots pedestrian safety signs

New crosswalk signs have been installed in installed several southwest Michigan cities as part of a joint research project by the Michigan Department of Transportation (MDOT) and Western Michigan University (WMU). The project involves testing the crosswalk signs as potential low-cost safety measures to increase pedestrian safety and motorist awareness. The signs are designed to be permanently affixed to the road but can be removed for the winter when snow removal is necessary. The signs will be removed i
August 21, 2015 Read time: 2 mins
New crosswalk signs have been installed in installed several southwest Michigan cities as part of a joint research project by the 1688 Michigan Department of Transportation (MDOT) and Western Michigan University (WMU). The project involves testing the crosswalk signs as potential low-cost safety measures to increase pedestrian safety and motorist awareness.

The signs are designed to be permanently affixed to the road but can be removed for the winter when snow removal is necessary. The signs will be removed in mid-November this year and the research results are expected to be published early next year.

The signs have been installed at 10 crosswalks in three roundabouts and six intersections in five MDOT Southwest Region communities. Installation sites were chosen primarily to get a variety of intersection configurations such as full intersections, roundabouts, mid-block crosswalks, etc. Dr Ron Van Houten, the traffic safety research expert leading the WMU study said several factors were considered, such as lane width, the messages on signs and the types of signs used.

Van Houten said the study already is showing signs of increased pedestrian safety. "People are looking for pedestrians with the signs there," he said. "Our data shows drivers slow a bit, their heads are turning, and that is a good thing in an urban environment."

Carissa McQuiston, MDOT project manager and non-motorised safety engineer, said the study is designed to increase pedestrian crossing awareness for pedestrians and drivers. Signs have been placed at crosswalks in the road at the edge lines, centre lines and lane lines.

"We have very good preliminary data that supports this installation as a way to inform drivers of pedestrian presence and highlight their crossing activity," McQuiston said. "With these installations, the researchers are collecting data about pedestrian safety, drivers yielding, and the durability of the signs."

Van Houten said while the signs are designed to withstand some abuse from traffic, there has to be a balance of durability and cost. "Ideally, they will last a long time," he said. "It will cost the department more money if they have to replace them frequently."

For more information on companies in this article

Related Content

  • Roadside monitoring used to target non-compliant trucks
    March 9, 2016
    The UK’s DVSA is utilising existing technology to identify non-compliant commercial vehicles and target repeat offenders while avoiding law-abiding companies. Enforcing the compliance of commercial vehicles (goods vehicles over 3.5 tonnes and vehicles with eight or more passenger seats) on the UK’s roads is the responsibility of the DVSA (the Driver and Vehicle Standards Agency). The Department for Transport created the executive agency about 18 months ago by merging the Driving Standards Agency (DSA) and t
  • City Safety reduces low speed accidents on Volvo’s XC60 and S60
    May 29, 2013
    It was four years ago that Volvo introduced its City Safety collision avoidance system which is designed to reduce the number and severity of low-speed accidents to the US market. However, a study in America by the Highway Loss Data Institute (HLDI) has shown that the results may not be as good as initially indicated by an earlier report. According to Volvo, statistics show that 75% of reported collisions occur at speeds of up to 30km/h (18.6mph) typically in urban traffic and in slow-moving traffic queues
  • Federal Signal supplies all the elements of end to end tolling
    January 31, 2012
    Manfred Rietsch, group president of Federal Signal Technologies (FST), talks about the recent acquisitions forming FST and the organisation's plans for the future. "Our philosophy is going to be about open access" Federal Signal has been on a buying spree. An energetic policy of acquisition over the past few months has seen the company reposition itself as an end-to-end provider of Electronic Toll Collection (ETC) systems with what it states is a portfolio of proven, best-in-class technologies which will al
  • Tech combo used to target overweight vehicles
    November 7, 2013
    UK enforcement agency VOSA is using a combination of ANPR and weigh-in-motion technology to detect and target overweight trucks on some of the busiest motorways.