Skip to main content

Michigan pilots pedestrian safety signs

New crosswalk signs have been installed in installed several southwest Michigan cities as part of a joint research project by the Michigan Department of Transportation (MDOT) and Western Michigan University (WMU). The project involves testing the crosswalk signs as potential low-cost safety measures to increase pedestrian safety and motorist awareness. The signs are designed to be permanently affixed to the road but can be removed for the winter when snow removal is necessary. The signs will be removed i
August 21, 2015 Read time: 2 mins
New crosswalk signs have been installed in installed several southwest Michigan cities as part of a joint research project by the 1688 Michigan Department of Transportation (MDOT) and Western Michigan University (WMU). The project involves testing the crosswalk signs as potential low-cost safety measures to increase pedestrian safety and motorist awareness.

The signs are designed to be permanently affixed to the road but can be removed for the winter when snow removal is necessary. The signs will be removed in mid-November this year and the research results are expected to be published early next year.

The signs have been installed at 10 crosswalks in three roundabouts and six intersections in five MDOT Southwest Region communities. Installation sites were chosen primarily to get a variety of intersection configurations such as full intersections, roundabouts, mid-block crosswalks, etc. Dr Ron Van Houten, the traffic safety research expert leading the WMU study said several factors were considered, such as lane width, the messages on signs and the types of signs used.

Van Houten said the study already is showing signs of increased pedestrian safety. "People are looking for pedestrians with the signs there," he said. "Our data shows drivers slow a bit, their heads are turning, and that is a good thing in an urban environment."

Carissa McQuiston, MDOT project manager and non-motorised safety engineer, said the study is designed to increase pedestrian crossing awareness for pedestrians and drivers. Signs have been placed at crosswalks in the road at the edge lines, centre lines and lane lines.

"We have very good preliminary data that supports this installation as a way to inform drivers of pedestrian presence and highlight their crossing activity," McQuiston said. "With these installations, the researchers are collecting data about pedestrian safety, drivers yielding, and the durability of the signs."

Van Houten said while the signs are designed to withstand some abuse from traffic, there has to be a balance of durability and cost. "Ideally, they will last a long time," he said. "It will cost the department more money if they have to replace them frequently."

For more information on companies in this article

Related Content

  • Electronic toll collection: Change is in the air
    November 7, 2024
    Trends in technology plus users’ comfort in adopting new advances indicate that the environment for a new electronic toll collection architecture is evolving. Hal Worrall considers what this might look like
  • ITS benefits escape public
    June 8, 2015
    John Kendall considers the public’s awareness of the benefits of ITS. While the results of developing ITS technology may be clear to readers of ITS International, there is far less evidence that drivers have any appreciation of what the technology is doing for them. So how aware are drivers of the developments that are designed to make their journeys less congested and safer?
  • High level support for US DOT decision on vehicle to vehicle technology
    February 4, 2014
    The US Department of Transportation's (DOT) National Highway Traffic Safety Administration (NHTSA) is to begin taking steps to enable vehicle-to-vehicle (V2V) communication technology for light vehicles. This technology would improve safety by allowing vehicles to communicate with each other and ultimately avoid many crashes altogether by exchanging basic safety data, such as speed and position, ten times per second. DOT research indicates that safety applications using V2V technology can address a large
  • Negative report for road safety cameras
    October 23, 2015
    An audit of the state’s speed cameras has found that the Queensland Police Service (QPS) and the Department of Transport and Main Roads (TMR) in Australia have strayed from best practice in using the devices to reduce speeding, with a resultant effect on road safety, according to PSNews online. In his report Road Safety: Traffic Cameras, Acting Auditor-General, Anthony Close found that in the past seven years the QPS had issued 3,760,962 speeding tickets from camera-based evidence, with TMR collecting AU