McCain’s RRIP to boost public safety at railroad crossings

McCain has unveiled its innovative railroad interface panel (RRIP), which it says boosts public safety and operational efficiencies at railroad crossings in adherence with the proposed regulations for the Federal Highway Administration (FHWA) standard. The device serves as a single termination panel for railroad field wires and isolators in any traffic controller cabinet. Data collected from six inputs enables traffic agencies to easily monitor railroad status, initiate track clearances and place the sig
October 16, 2014 Read time: 2 mins
772 McCain has unveiled its innovative railroad interface panel (RRIP), which it says boosts public safety and operational efficiencies at railroad crossings in adherence with the proposed regulations for the 831 Federal Highway Administration (FHWA) standard.

The device serves as a single termination panel for railroad field wires and isolators in any traffic controller cabinet. Data collected from six inputs enables traffic agencies to easily monitor railroad status, initiate track clearances and place the signal in flash should a fault occur.

Most railroad and traffic cabinet communications are manually wired in the field by traffic technicians,   cumbersome task that easily translates into lengthy installations, maintenance and troubleshooting calls, which ultimately cost taxpayers money. McCain's RRIP reduces the time required to establish communications and allows technicians to visually confirm wiring accuracy with LED status indicators. In addition, having a single system citywide rather than custom wiring at each crossing, makes maintenance faster and more efficient.

"Modern technology enables more and more data to be gathered at railroad crossings," said Douglas Acker, hardware engineering manager at McCain Inc. "We are proud to introduce a simple, yet elegant solution to enable agencies to leverage that data while circumventing the age-old issues surrounding custom wiring at railroad crossings."
Urban Traffic Control

For more information on companies in this article

Related Content

  • Control rooms adapt to tech changes
    July 8, 2019
    From IP-based systems to an increasing array of choice, traffic and transit management has changed a lot in the last few years. Adam Hill talks to some of the leading players in the control room business
    Read More
  • Prevention is better than cure says Antaira’s David Zaveski
    November 2, 2016
    Antaira’s David Zaveski looks at how to improve the resilience of Ethernet systems. Detection and monitoring, and the subsequent management of transport systems, is becoming ever more sophisticated and also integrated as ITS spreads wider across cities and along highways and rail corridors.
    Read More
  • Mobinet counters weighty cross border concerns
    November 9, 2017
    A Mobinet pilot is combining onboard weighing with V2X comms to streamline vehicle weight enforcement. David Crawford reports. Pan-European, cross-border weigh-in-motion (WIM) for trucks is now a practical possibility, following successful Scandinavian trials within the EU-co-funded Mobinet (Internet of Mobility) programme. New technology is using strain sensors, located on load-bearing components and routinely installed in truck fleet management systems.
    Read More
  • TM 2.0 boost TMC data feed and driver influence
    November 15, 2017
    TM 2.0 views connected vehicles and V2I as two-way communications channels, benefitting traffic management and drivers, as Alan Dron discovers. As connected vehicles are progressively rolled out there will come a point at which traffic managers and traffic management centres (TMCs) will have to gear up to cope with a rapidly-evolving road scenario. The TM 2.0 Platform (see box) is promoting a concept of new-generation traffic management (which carries the same TM 2.0 title) and is studying how future T
    Read More

Highlighted Content