Skip to main content

Illuminated road studs aid roundabout safety

In a bid to improve safety at the Sheriffhall roundabout near Edinburgh, Scotland, Clearview Traffic has been working with BEAR Scotland on an innovative accident reduction project at the complex six-arm gyratory roundabout which is used by over 42,000 vehicles per day. The project, which Clearview says is the first of its kind in the UK, uses the company’s IRS2 intelligent hardwired road stud to increase driver awareness and improve lane discipline on and off the roundabout. Improvements and efficien
July 15, 2014 Read time: 2 mins
In a bid to improve safety at the Sheriffhall roundabout near Edinburgh, Scotland, 557 Clearview Traffic has been working with BEAR Scotland on an innovative accident reduction project at the complex six-arm gyratory roundabout which is used by over 42,000 vehicles per day.

The project, which Clearview says is the first of its kind in the UK, uses the company’s IRS2 intelligent hardwired road stud to increase driver awareness and improve lane discipline on and off the roundabout.

Improvements and efficiencies made to the traffic signal-controlled roundabout in recent years have dramatically increased its capacity. BEAR Scotland was keen to ensure safety measures were improved in line with the increased use of the roundabout. Investigations found that inadvertent lane drifting was a significant contributory factor to negotiating it safely.

To address this issue, whilst at the same time causing minimal impact on the existing road markings and supporting infrastructure of the roundabout, BEAR Scotland and Clearview Traffic devised a unique road stud layout scheme that would guide the A720 traffic from either direction safely around and off the roundabout.

With the new system in place, as soon as the traffic signal on the entrance to the roundabout turns green, studs embedded in the road surface immediately illuminate and guide drivers onto the appropriate lanes of the roundabout. As the traffic signal turns red, all the studs on that section switch off and the studs on the next section illuminate as the corresponding traffic signal turns green. In this way, drivers now get an illuminated green phase to guide them all the way around and off the roundabout, with clear visual definition of the lanes to heighten lane discipline and reduce preventable collisions.

For more information on companies in this article

Related Content

  • Need for performance standards for road user charging systems
    February 2, 2012
    GNSS-based road use metering systems need performance metrics, as well as ways to test and reliably compare them. Bern Grush and Joaquín Cosmen write about the function of the GNSS Metering Association for Road-use charging (GMAR), recently set up to address this issue
  • Speed camera law signed for six California cities
    October 19, 2023
    Enforcement pilots can start in LA, San Jose, Oakland, Glendale, Long Beach & San Francisco
  • Cohda trial proves C-ITS can work in tunnels
    August 29, 2019
    Connected cars require uninterrupted signals to ensure driving safety. Going underground creates problems – but a trial in Norway suggests that there might be light at the end of the tunnel… As connectivity becomes increasingly important for transportation – in particular for connected and autonomous vehicles (C/AVs) - the problem of ‘blackspots’ and dead zones where signals fail or drop out is a pressing one. But developments early this year suggest that advances in technology might be on the brink of d
  • Asecap Days 2023: Data drives the best decisions
    December 22, 2023
    Almost all the data being collected by highway operators is going to waste. But if firms collect and analyse these ‘vast lakes of data’ they can investigate threats, monitor management systems and drive up revenues, delegates were told at Asecap Days 2023. Geoff Hadwick reports